CRYSTORAMA 1138-CH-CL-MWP 8 Light Crystal Chandelier Instruction Manual
- June 12, 2024
- CRYSTORAMA
Table of Contents
ASSEMBLY INSTRUCTION MODEL #1138-CH-CL-MWP
Crystal Sets
A. 50 Sets. (1)14mm+AS9-2″
B. 8 Sets. (3)14mm + (1)Square + (7)14mm+AS9-2.5″
C. 16 Sets. (20)14mm
D. 8 Sets. (1)Ring + (1)14mm + AS9-2.5″
E. 8 Sets. (1)Square + (1)14mm + AS9-2.5″
F. 8 Sets. (14)14mm
G. 1 Piece. (3)14mm+AS8-40mm Ball
WARNING:
Electrical Danger Turn Power Off
All electrical components must be installed by a licensed electrician in accordance with the National Electric Code and the appropriate local electrical codes
You will need 8- Candelabra Base Bulb 40 Watts recommended 60 Watts Max.
USE LED BULBS FOR EXTENDED USE
The fixture is Damp rated
HOW TO INSTALL:
Place the fixture parts on a soft cloth-covered platform before installation of fixture.
-
To install the 10″arms, slightly loosen each screw on the metal plate.
Pull a female plug through a hole in the upper metal plate.
Connect the male plug at the end of the upper arm with the female plug that was just pulled. Push the end of the arm with the metal tab through the hole until stopped by the metal tab (this should also push the wires and plugs back inside the metal plate).
Twist the metal tab counter-clock wise until both inserts lock onto the loose screws.
Tighten the screw securing the arm in place. Repeat for all 10″arms. -
Screw the Center column kit onto the distributor box.
-
Place the bottom bowl, metal washer, bobeche and metal washer in that order, over the distributor box. Secure with the finial.
-
Attach the mounting bar onto the outlet box.
-
Decide the desired hanging height and adjust the chain to the correct length.
-
Raise the fixture up and do the wire connection. Attach the canopy over the mounting bar and secure with collar ring.
-
Dress the crystals as illustrated.
WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer and/or birth defects or reproductive harm. For more information go to www.p65warnings.ca.gov
Part Number
- Outlet Box
- Female Plug
- Male Plug
- Arm with Metal tab
- Plate
- Screws
A.(1)-Mounting hardware
Wire connector ×2.
Mounting bar x1.
Lock washer ×1.
Hex nut ×1.
Nipple ×1.
Screw ×2.
B. (1)-Canopy (W5″xH1″)-XSN1130CHCAN5IN
C. (1)-Collar Ring
D. (1)-Collar Loop-XSN1130CHLOOP
E. (1)-Chain (4mmx72″)-XSN1130CHCHA4MM
F. (1)-Center Column Kit Loop
G. (1)-Center Column Kit
Top Bowl ; Ø6″, 8pin,13mm center hole. -XSN1138CHDIBOB8PN
Glass Vase; H8″
Top Bobeche ; Ø4″, 5pin,24mm center hole. -XSN1135CHBOB4IN
Glass Vase; H6″
Metal Cover ; H1.5″
H. (8)-10″ Arms with holder-XSN500CHARM10INKD
I. (10)-Bobeche ; Ø4″, 5pin,24mm center hole. -XSN1138CHBOB4IN
J. (8)-Male Plug
K. (1)-Distributor box with female plug ; Ø5 1/2″ ; 11mm center hole.
L. (1)-Bottom bowl ; Ø6″, no pin, 13mm center hole. -XSN1138DIBOB6IN
M. (2)-Metal washer
N. (1)-Finial-XSN1130CHFIN
O. (8)-PVC candle sleeve ; H4″