JUNO P6300 Trac Adapter Instruction Manual
- June 12, 2024
- Juno
Table of Contents
JUNO P6300 Trac Adapter
Product Information
The Juno Trac Adapter is a component used for installing fixtures on Juno Trac tracks. It allows for easy and secure attachment of fixtures to the track system. The adapter comes in different sizes and styles, and it is important to select the appropriate one for your specific track.
Product Usage Instructions
Fixture Installation
-
Step 1: Find the latch and the polarity line. Align the parts as shown in Figure 1.
-
Step 2: Pull down the latch while rotating the adapter box 90 degrees clockwise, as shown in Figure 2.
-
Step 3: The final position is when the latch snaps into place between the extrusion rails, with the arrows on the latch pointing towards the polarity line, as shown in Figure 3.
Second Circuit Positioning
- Step 1: Raise the contact marked P (on switch side) by inserting a thin screwdriver blade under the contact. Pull it up into position as shown in Figure 4.
-
Step 2: Insert the contact support (supplied with the 2-circuit Trac section) by tilting and snapping it into position under the P contact, as shown in Figure 5.
-
Step 3: Ensure the contact support is snapped and locked into position, as shown in Figure 6. Follow the instructions for inserting into the track.
Troubleshooting
If you encounter any issues with the fixture, refer to the following troubleshooting steps:
| Problem | Cause | Remedy |
|---|---|---|
| Fixture doesn’t turn on | – Track not energized |
– Adapter switch is in the Off position
– Fixture installed incorrectly| – Ensure track has power
– Ensure the power switch on the track fixture adapter is in the On
position
– Ensure fixture is installed correctly with the arrows on the
latch pointing towards the polarity line (refer to Figure 3)
– Ensure contacts aren’t bent from installing the fixture
incorrectly (refer to Figure 7)
If the problem persists:
- Ensure P contact isn’t bent from adjusting incorrectly (refer to Figure 8).
- Check for any bent contact from adjusting the wrong contact (refer to Figures 4, 5, & 6 for proper adjustment method).
For single circuit positioning, use the T, TU, and R Series Track. For two circuit positioning, use the TU Series Track (refer to Figure 9).
Remember to move the switch on the adapter to the On position to ensure proper functionality.
One Lithonia Way
Conyers, GA 30012
1-800-705-SERV (7378)
www.acuitybrands.com
©2020 Acuity Brands Lighting,
Inc. P6300 Rev 10/2022
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>