juno QC6 Housing with LED Retrofit Trims Instruction Manual

June 9, 2024
Juno

juno QC6 Housing with LED Retrofit Trims

QC6 Housing with LED Retrofit Trims

SAVE THESE INSTRUCTIONS

IMPORTANT SAFETY INFORMATION

For your protection, read carefully before proceeding with installation. To be installed by a qualified electrician. Heavy duty gloves should be worn to protect hands from sharp edges. Protective eye wear should be worn to prevent injury to eyes.

  1. Electric current can cause painful shock, serious injury, or death. For your safety, remember the
    following:
    • Turn off the power supply.
    • Ground the fixture to avoid potential electrical shocks.
    • Do not handle an energized fixture.
    • Check all electrical connections to be sure they are tight and correct.

  2. Specific safety information concerning LED trim.
    • Match fixture and LED trim based on product labeling.
    • Do not remove or insert LED trim when power is on.
    • Do not subject LED trim to undue pressure as it may cause LED trim damage.
    • Protect operating LED trim from direct contact with water

  3. Make sure appropriate trim and rough-in are used. Match labels on both fixture and trim.

  4. Install and wire fixtures per all applicable national and local electrical codes.

  5. This product may be installed in either type IC or Non-IC applications.

CAUTION: RISK OF FIRE
Most dwellings built before 1985 have supply wire rated 60°c. Consult a qualified electrician before
installation.

Mount per all national and local codes.

USING INSULATION:
Housings are designed for direct contact with insulating materials which are approved for this application (Fig. 1).
Save These Instructions

USING GASKETS (only available for some models):
Housings are supplied with pre-installed gaskets for energy savings and to comply with energy code air leakage requirements per ASTM E283.

INSTALLATION OPTION 1: JOIST CEILING
Step 1: Extend bar hangers to fit between joists. Bar hanger foot is contoured to easily align with bottom of joist (Fig. 2). Position fixture by hammering Real-Nails® into joists (Fig. 3).
Save These Instructions
Save These Instructions

Note: Bar hanger may be shortened to fit 12” framing or smaller by breaking at score lines.

Note: Nail can be removed with hammer claw to allow easy repositioning of fixture without damaging bar hanger or nail (Fig. 5).

Save These Instructions

Step 2. Slide fixture along bar hangers into desired location. Use locking screws or slot to secure (Fig. 4).
Save These Instructions

Step 3. Follow steps 1-4 under Electrical Connection.

Step 4. When installing in drywall, cut appropriate sized hole. After installing drywall, if necessary, adjust fixture for ceiling thickness by loosening hex screws that attach the round housing to the plaster frame. (Fig. 2)

INSTALLATION OPTION 2: SUSPENDED CEILING
Step 1.
Locate center of proposed opening on ceiling tile and cut appropriate sized hole

Step 2. Place ceiling tile in T-bar grid.

Step 3. Place fixture into position and snap bar hanger foot with integral T-bar clips onto T-bars ( Fig. 6). Additional holes provided for securing with wire or screws as needed (Fig. 7).
Save These Instructions
Save These Instructions

Step 3: Connect supply wires to fixture wires with proper size wire nuts (not supplied) so as to cover all bare current carrying conductors. Connect black fixture wire to hot, white fixture wire to neutral and green fixture wire to ground.

Note: some housings include quick connectors in the junction box as an alternative to wire nuts. If applicable, strip supply wire 3/8˝, insert each supply wire into appropriate junction box connector.

Step 4. Place all wiring and connections back in wiring box and replace cover.

TRIM INSTALLATION :

This housing is only intended to be used with trims marked on the housing. For instructions on how to install the trim, refer to the instructions supplied with the trim.

CUSTOMER SUPPORT

One Lithonia Way, Conyers, Georgia 30012• Telephone 1-800-705-7378
Consulter notre site webwww.acuitybrands.com/juno-recessed
© 2022 Acuity Brands Lighting, Inc.

Documents / Resources

| juno QC6 Housing with LED Retrofit Trims [pdf] Instruction Manual
QC6, QC5, QC4, QC6 Housing with LED Retrofit Trims, QC6, Housing with LED Retrofit Trims, LED Retrofit Trims, Retrofit Trims, Trims, Housing
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals