JUNO JFX Series RGBW RF Controller Instruction Manual

June 9, 2024
Juno

JUNO JFX Series RGBW RF Controller

JUNO-JFX-Series-RGBW-RF-Controller-fig-1

WARNING: This RF Controller should only be powered by ACCUDRIVETM JFX Series Class 2, 24VDC Drivers. Use of nonACCUDRIVE™ drivers may damage controller and void warranty. See Drivers & RF Controller Spec sheet for more detailed
information. Failure to follow instructions will void product warranty.

IMPORTANT SAFETY INSTRUCTIONS

  • Read all these instructions before starting installation.
  • Keep these instructions in a safe place for future reference.
  • Only qualified electricians in accordance with local codes should install these fixtures.
  • De-energize electrical circuit at circuit breaker prior to installation process. Always ensure power is off before making any changes to installation.
  • Do not connect directly to high voltage power. Must be connected to approved Class 2 LED driver.
  • Do not disassemble or modify these products beyond instructions or warranty will be voided.
  • Only install in an Indoor dry location.
  • Ensure wire gauge used from driver to controller and controller to LED strip is sufficient to maintain a voltage drop under 3% (See Spec Sheet for details).
    SAVE THESE INSTRUCTIONS

INSTALLATION INSRUCTION

  • Step 1. (RF Controller – System Installation)
    Once mounting locations are determined for the LED driver junction box, RF Controller, and LED strips refer to controller wiring guide (Figure 1).

JUNO-JFX-Series-RGBW-RF-Controller-fig-3

  • Step 2. (RF Controller – Sync Remote to Receiver)
    Remote requires 3x AAA 1.5V batteries (Not Included).

    • Press the Power button to turn on remote (Figure 2).
    • Press LEARNING KEY button on receiver (Figure 1).
    •  Swipe finger on color wheel. LED strip will flash to indicate learning. Once flashing has stopped the setup is complete.

JUNO-JFX-Series-RGBW-RF-Controller-fig-5

Reset Receiver / Unpair
If necessary, the remote can be unpaired from the receiver. To unpair hold the LEARNING KEY down for 5 seconds until LED light strip flashes twice. This will delete the controller ID. To re-sync remote follow steps above. In the event the remote become inoperable cycle power feed to LED strips. If problem persists reset receiver and re-sync remote.

WARRANTY

5-year limited warranty. Complete warranty terms located at: www.acuitybrands.com/CustomerResources/Terms_and_conditions.aspx
Technical Services Phone 888-387-2212

ABOUT COMPANY

  • One Lithonia Way
  • Conyers, GA 30012
  • (800) 705-SERV (7378)
  • www.acuitybrands.com
  • ©2021 Acuity Brands Lighting, Inc.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals