JUNO Trac Adapter Instruction Manual
- June 12, 2024
- Juno
Table of Contents
JUNO Trac Adapter
Product Information
The Juno Trac Adapter is a versatile accessory that allows for easy installation of fixtures onto Juno track systems. It is compatible with various sizes and styles of Juno Trac adapters.
Key Features
- Easy installation
- Compatible with Juno track systems
- Versatile design
Product Usage Instructions
Fixture Installation
- Find the latch and the polarity line on the adapter box.
- Align the parts as shown in Fig. 1.
- Insert the adapter box into the track.
- Pull down the latch while rotating the adapter box 90 degrees clockwise.
- The latch should snap into place between the extrusion rails. Ensure that the arrows on the latch point toward the polarity line.
Second Circuit Positioning
-
Raise the contact marked P (on switch side) by inserting a thin screwdriver blade under the contact. Pull it up into position as shown in Fig. 4.
-
Insert the contact support (supplied with the 2-circuit Trac section) by tilting and snapping it into position under the P contact as shown in Fig. 5.
-
Ensure that the contact support is snapped and locked into position as shown in Fig. 6.
-
Step 1 Raise the contact marked “P” (on switch side) by inserting a thin screwdriver blade under contact. Pull up into position as shown. (Fig. 4)
-
Step 2 Insert contact support (supplied with 2-circuit Trac section) by tilting and snapping into position under the “P” contact as shown. (Fig. 5)
-
Step 3 Ensure contact support is snapped and locked into position. (Fig. 6) Follow instructions for inserting into track.
Troubleshooting
If you encounter any issues with the fixture, refer to the following troubleshooting steps:
| Problem | Cause | Remedy |
|---|---|---|
| Fixture doesn’t turn on | Track not energized |
Adapter switch is in the Off position
Fixture installed incorrectly| Ensure track has power
Ensure the power switch on the track fixture adapter is in the On
position, see Fig. 9
Ensure fixture is installed correctly, with the arrows on the latch
pointing towards the polarity line as shown in Fig.
3
P Contact adjusted incorrectly| Ensure P contact isn’t bent from adjusting
incorrectly, see
Fig. 8
Bent contact from adjusting the wrong contact, see Fig.
4, 5 , & 6 for proper
adjustment method| Adjust the P contact correctly as shown in Fig.
8
Note: The correct single circuit and two circuit positions are shown in
Fig. 8 and Fig. 9 respectively.
Always make sure the switch on the adapter is in the On position for proper functionality. For further assistance, refer to the complete user manual or contact customer support.
One Lithonia Way
Conyers, GA 30012
1-800-705-SERV (7378)
www.acuitybrands.com
©2020 Acuity Brands Lighting,
Inc. P6300 Rev 10/2022
Juno Trac adapter size and style may vary.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>