SKYDANCE PK3 Rotary Panel RF Remote Controller User Manual
- June 4, 2024
- SKYDANCE
Table of Contents
- SKYDANCE PK3 Rotary Panel RF Remote Controller
- Product Overview
- Features
- Technical Parameters
- Warranty
- Safety and EMC
- Environment
- Mechanical Structures and Installations
- Installation Diagram
- Knob function
- Match Remote Control (two match ways)
- Safety information
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
SKYDANCE PK3 Rotary Panel RF Remote Controller
Product Overview
Model No.: PK1, PK2, PK3
Rotary dimming/1-3 color/Wireless remo te 30m distance/CR2032 battery
Features
- Apply to a single color, dual color or RGB LED controller.
- Rotate the knob to change RGB color, color temperature, or brightness, support long press or twice click operation.
- Each remote can match one or more receivers.
- CR2032 battery powered.
- Removeable and stick anywhere easily, or mount on wall use panel base.
Technical Parameters
Warranty
Safety and EMC
Environment
Mechanical Structures and Installations
Replace battery:
Note: Before the first use, please remove the protective film on the battery.
Typical base is as below:
Installation Diagram
To fix the panel, two options are offered for selection:
Option 1: fix it on the wall with two screws.
Option 2: adhere it to the wall with a paster.
Knob function
PK1 Single color dimming remote
- Push: Turn on or off the light.
After turning on the light:
- Rotate: Rotate the knob to adjust brightness(2.5 turns, 50 levels).
- Long push(1-6s): Continuous 256 levels of brightness adjustment
PK2 Color temperature remote
- Push: Turn on or off the light.
After turning on the light:
- Rotate: Rotate the knob to change the color temperature or brightness (2.5 turns, 50 levels).
- Push twice: Switch between color temperature or brightness adjustment.
- Long push(1-6s): Continuous 256 levels of brightness adjustment.
PK3 RGB remote
- Push: Turn on or off the light.
After turning on the light:
- Rotate: Rotate the knob to change RGB color (3 turns, 60 colors) or brightness (2.5 turns, 50 levels).
- Push twice: Switch between RGB color or brightness adjustment.
- Long push(1-6s): Continuous 256 levels of brightness adjustment
Match Remote Control (two match ways)
The end user can choose the suitable match/delete ways. Two options are offered for selection:
Use the controller’s Match key
Match: Short press the match key, and immediately push the knob. The LED
indicator fast flash a few times means the match is successful.
Delete: Press and hold the match key for 5s to delete all match, The LED
indicator fast flash a few times means all matched remotes were deleted
Use Power Restart
Match: Switch off the power, then switch on the power, repeat again.
Immediately push the knob 3 times. The light blinks 3 times means the match is
successful.
Delete: Switch off the power, then switch on the power, repeat again.
Immediately push the knob 5 times. The light blinks 5 times means all matched
remotes were deleted.
Safety information
- Read all instructions carefully before you begin this installation.
- When installing the battery, pay attention to the battery’s positive and negative polarity. A long time without the remote control, remove the battery. When remote distance becomes smaller and insensitive, replace the battery.
- If no response from the receiver, please re-match the remote.
- Gently handle the remote, beware of falling.
- For indoor and dry locations use only
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>