SEGWAY 051403U Ninebot eKickScooter C2 Owner’s Manual

SEGWAY 051403U Ninebot eKickScooter C2 Owner’s Manual

The manufacturer reserves the right to make changes to the product, release firmware updates, and update this manual at any time. Visit www.segway.com or check the Segway-Ninebot app to download the latest user materials. You must install the app, activate your KickScooter, and obtain the latest updates and safety instructions.

The pictures shown are for illustration purposes only. The actual product may vary

Diagram

C2

C2 C2 Pro

C2 Pro

Dashboard & Power Button

Power Button: Press the button to power on the scooter; press and hold the button for 3 seconds to power it off. When the scooter is on, press the button to turn on/off the headlight, and press twice to switch between the speed modes.
Speedometer: It displays the current speed of the scooter, as well as error codes.
Speed Mode: There are three modes available. The top speed is as follows:

Error Notification: It indicates that the scooter has detected an error.

Bluetooth: It indicates that the scooter has been successfully connected to the mobile device.

Temperature Warning: It indicates that the battery temperature has reached 55°C (131°F) or is below 0°C (32°F).

• At this point, the vehicle cannot accelerate normally and may not be charged. Do not use until the temperature has reverted to the normal range.

Locking Reminder: When the icon lights up, it means the scooter is locked. If abnormal movements are detected, the scooter will start beeping and the tail light will falsh.

Battery power: The total battery power equals 5 bars.

• The battery power is very low when the first battery bar is red. Please charge your scooter immediately.

Specifications

mm (35.8 × 15.7 × 37.8 in)

| Approx. 910 × 400× (885/960/1035)

mm (35.8 × 15.7 × 34.8/37.8/40.7 in)

Folded: Length × Width × Height| Approx. 910 × 400× 500 mm (35.8 × 15.7 × 19.7 in)
Net Weight| Approx. 10.5 kg (23.2 lbs)| Approx. 10.7 kg (23.6 lbs)
Rider| Max. Payload| 50 kg (110 lbs)| 60 kg (132 lbs)
Recommended Age| 6+| 9+
Required Height| 3’9”–5’4” (120–165 cm)| 3’9”–5’9” (120–180 cm)
Machine| Max. Speed| Approx. 16 km/h (9.9 mph)| Approx. 20 km/h (12.4 mph)
Theoretical Range [1]| Approx. 9 km (5.6 miles)| Approx. 19 km (11.8 miles)
Max. Slope| Approx. 5%
Traversable Terrain| Mostly smooth roads or normal asphalt, tarmac roads
Operating Temperature| -10–40°C (14–104°F)
Storage Temperature| -10–50°C (14–122°F)
IP Rating| IPX4
Duration of Charging| Approx. 3.5 h| Approx. 4 h
Battery| Nominal Voltage| 21.6 V
Max. Charging Voltage| 25.2 V
Charging Temperature| 0°C–45°C (32–113°F)
Nominal Capacity| 54 Wh| 108 Wh
Nominal Energy| 2500 mAh| 5000 mAh
Battery Management System| Protection against overvoltage/undervoltage/short circuit/overcur-

rent/overheat

Motor| Nominal Power| 150 W
Max. power| 260 W
Charger| Model| NBW25D201D0D| NBW25D201D5N-US
Output Power| 24.2 W                          100-240| 36.3 W
Input Voltage| V~ 50-60 Hz
Max. Output Voltage| 25.2 V
Rated Output| 24.2 V    , 1 A| 24.2 V    , 1.5 A
Tire| Tires| 7-inch rubber solid tires
[1]: Theoretical Range: tested while riding with a full battery, 165 lbs (75 kg) load, 77°F (25°C), 70% of max. speed on average on pavement.

• Some of the factors that affect range include speed, load, number of starts and stops, ambient temperature, etc

Certifications

This product is certified to ANSI/CAN/UL-2272 by TUV Rheinland.
The battery complies with UN/DOT 38.3.
The battery complies with ANSI/CAN/UL-2271.

Federal Communications Commission (FCC) Compliance Statement for USA

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 5mm between the radiator & your body.

Industry Canada (IC) Compliance Statement for Canada

This device complies with Industry Canada license-exempt RSS standard (s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

CAN ICES-3 (B)/NMB-3(B).

Model: 051404U
FCC ID: 2ALS8-KS0017
IC: 22636-KS0017

References

• Home | Segway

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>