SUNRISE MEDICAL ADV5315 Adventus Adaptor Bar Instruction Manual
- June 12, 2024
- SUNRISE MEDICAL
Table of Contents
SUNRISE MEDICAL ADV5315 Adventus Adaptor Bar Instruction Manual
1. Safety
Symbols
⚠ Warning! Risk of serious injury or death. An operation that, if not
correctly performed, may lead to injury to the operator or others.
CAUTION! Risk of material damage. An operation that, if not correctly
performed, may lead to material damage.
ℹ INFO Particularly important or explanatory information
General instructions
These instructions shall always be followed when placing the mounting ADV5
Adventus adaptor bar universal on a wheelchair. Adjustment of the Adventus
wheel is described in the user manual of the Adventus wheel.
⚠ WARNING!
Assembly work or changes made to the mounting set must be carried out by
trained service technician, reseller or another person assigned by Decon.
2. Overview
- A Adapterbar
- B Fork adapterbar
- C Adapterkit
- D QR pin
3. Assembly adapter kit
First mount the Adapterkit (C). Mount the holders so that they still can be moved along the wheelchair chassis
ℹ INFO
The clamp should be mounted as close as possible to the holder of the adaptor
bar. Mount the adaptorbar (A)
into the holders and lock it into place using the QR Pins (D). Now tighten the
screws sitting in the clamps that connects to the frame of the wheelchair.
ℹ INFO
After the screws are tightened check that the adaptor bar still can be removed
from its holders without excessive force. If the adaptor bar is stuck in its
holders loosen the screws on one side and adjust the position.
⚠ WARNING!
The screws holding the clamps (G) shall be tightened to: 7-9Nm of torque (M6)
10-15Nm of torque (M8) Loctite 243 or eq. must be applied if washers are not
used.
4. Adjustment of the adaptor bar
Mount the fork onto the adaptor bar.
Mount the adjustment toll onto the fork (B). Remove the screws in the fork that locks the rotation (see picture bellow). Also make sure that the fork sits in the center of the wheelchair.
ℹ INFO
The images are shared with other assembly instructions and are only for
showing the adjustment of the Fork / Adapterbar.
Now rotate both the adapter bar and the fork to a position where the adjustment tool shows the correct angle and the fork doesn’t collide with the footrests. If possible, make sure that the fork doesn’t sit lower than the footrest and that the height, if possible, corresponds to the picture bellow.
Reassemble the screw in the hole that is fits the best, see picture bellow for example.
Now tighten the screws that sits in the clamp of the adaptor bar. Slightly tighten all four screws on the clamp. It is important to not completely tighten each screw, but to slowly tighten all four, a little at a time. Keep tightening until all four screws are secured (30-35Nm of torque). Also make sure one last time that the fork is cantered and the angle of the adjustment tool is still correct.
Check one last time that all screws are properly secured. Now see the user manual of Adventus to continue the installation. This can be downloaded from www.decon.se/en/
Decon Wheel AB Södra Ekeryd 119, SE-314 93 Hyltebruk, Sweden
Tel: +46 (0)345 40880
Fax: +46 (0)345 40895
E-mail: info@decon.se
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>