PNI SafeHome DIM202 Touch Dimmer Switch User Manual

: June 12, 2024
: PNI

Table of Contents

Technical specifications
Connection diagram
Installation
Dimensions
Troubleshooting
Simplified EU declaration of conformity
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

PNI SafeHome DIM202 Touch Dimmer Switch User Manual

Warnings

To prevent the risk of electric shock, switch off the mains supply before starting the installation of the switch.
Do not carry out maintenance operations on the switch if it is connected to the mains.
This switch must be installed by an authorized electrician only.
It is important to make all connections according to the connection diagram below.
Make sure that the wires are not under tension and that the screws are well tightened.
Do not exceed the maximum recommended load.

Technical specifications

Rated voltage: 110V-240V AC
Rated current: max. 3.2A
Maximum power: 700W/gang
Energy consumption: 0.2A
Dimensions: 86 x 86 x 35 mm
Operating temperature: -26°C ~ +80°C

Connection diagram

L- Line
N – Neutral

Installation

Remove the front panel with a screwdriver.
Connect the wires according to the diagram above.
Fix the switch in the wall box with the help of screws. Note: This device can only be mounted in a wall box with left-right / up-down screw support.
Mount the capacitor according to the diagram below.
Mount the glass panel (pressing from top to bottom).
Switch on the mains supply.
Wait for about 10 seconds then test the touch button.

Dimensions

Turn the light on/off and the Dimming function (reducing the light intensity)

One gang touch switch PNI SafeHome DIM101:
Touch the central button to turn on/off the light.
Touch the + button to increase the light intensity.
Touch the – button to reduce the light intensity.

Two gang touch switch PNI SafeHome DIM202:
Touch one of the two buttons to turn the light on/off.
When the light is on, hold your finger on one of the two buttons to gradually reduce the light intensity.
When the light is off, hold your finger on one of the two buttons to gradually increase the light intensity.

Troubleshooting

The bulb light glows dimly or flickers.

If the light bulb does not light up, lights up weakly or flickers, please connect the capacitor in the package between the Neutral wire and Line wire according to the diagram below (in parallel with the light source):

The switch is installed and connected correctly, but the touch button does not work.
First make sure that the wires are connected correctly and that the bulb is not burned out.

Cut off the power for 1 minute.
Restart the power supply.
Wait 10 seconds and then touch the buttons to operate the switch.

Compatible lamps or bulbs

PNI SafeHome DIM101 and PNI SafeHome DIM202 switches are only compatible with lighting sources that support the Dimming function (light intensity adjustment).

Simplified EU declaration of conformity

ONLINESHOP SRL declares that the PNI SafeHome DIM101 / PNI SafeHome DIM202 touch switch is in compliance with the EMC Directive 2014/30/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.mypni. eu/products/9177/download/certifications