MKA-SEAT Sprout Seat User Manual
- October 30, 2023
- Sprout
Table of Contents
MKA-SEAT Sprout Seat
Product Information
The MakerWall Seat is a modern and simple American-made product designed for use by children and adults. It consists of two sides (left and right), a seat (Cc), and five dowels (Dd). The product also includes a slotboard with four slots to position the seat at different heights. The bottom row of slots is suitable for children, and the upper row is suitable for adults. The seat height can be adjusted to 13 inches or 18 inches. The slotboard height from the floor ranges from 0 inches to 9.5 inches, depending on the slot position.
Product Usage Instructions
- Before starting, ensure that the slotboard is installed at the correct height for the intended user.
- Press the five dowels (Dd) into the left side (Aa) by aligning them with the nubs and applying constant pressure until they crush on the nub.
- Lift the left side (Aa) with the dowels above the right side (bB), and carefully press in one dowel at a time, moving from left to right. Once all the dowels have started entering their holes, finish pressing them in completely by pushing firmly or using a rubber mallet.
- Gently set the seat (Cc) on top of the sides with the indented side facing back towards the slotboard, and the shelf slots facing down.
- Push the seat (Cc) tight against the slotboard to tighten the joints.
Note: The assembly should be done by an adult. To disassemble, loosen tabs and remove Seat Cc from sides before removing sides from slotboard.
If you need help with the product, please contact our customer service agent at +1 (833) 530-0033.
STOP
Frustrated? Need Help?
Talk to our customer service agent at: +1 (833) 530-0033
For disassembly, loosen tabs and remove Seat c C from sides before removing sides from slotboard.
PARTS
BEFORE YOU START
Install Slotboard so that the seat will be at the correct height for the
intended user. 
ASSEMBLY INSTRUCTIONS
-
Press (5) Dowels d into Left Side a . They will crush on the nub as they go in. This will prevent the dowels from rotating.
-
Lift Left Side a with the (5) Dowels d above Right Side b , and carefully press in one dowel at a time, moving from left to right.
Once all the dowels have started entering their holes, finish pressing them in completely by pushing firmly or using a rubber mallet.
-
Holding both sides together, put into Slotboard at desired height per
-
Gently set Seat c on top of sides with the indented side facing back towards the slotboard, and the shelf slots facing down.
-
Push Seat c tight against slotboard to tighten the joints.
QUARK ENTERPRISES, LLC PO BOX 1123, PROVO, UT 84601
MODEL NO. MKA-SEAT
DOCUMENT: AI-MKA-SEAT
WWW.SPROUT-KIDS.COM
COPYRIGHT QUARK ENTERPRISES 2022
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>