IN THE BOX

Robot Vacuum

Remote Control
(AAA Batteries not included)

Vacuum Brushes x 2

Micro USB Charger

Quick Start Guide

Warranty Card

DEVICE OVERVIEW

INITIAL INSTALLATION

Use a screwdriver (not included) to install 2 AAA batteries (sold separately) in the remote control.

Plug the included micro USB cable into the charging port on the side of the vacuum. The indicator light will be red while the vacuum is charging and will turn off once the battery is full.

USING THE VACUUM

Align the square notches on the 2 vacuum brushes to the square pegs on the vacuum base, and press the brushes down to secure. Simply pull the vacuum brushes from the vacuum base to remove.

Flip the switch on the side of the vacuum to the ON position to turn on the vacuum suction and music. Flip the switch on the controller to the ON position. To turn off the music, press the Music Sutton on the controller.

This robot vacuum features Remote and Auto modes. Flip the switch at the bottom of the vacuum to Remote Mode to control the vacuum with the included remote. Switch to Auto Mode to let the vacuum navigate around your home on its own!

Each charge provides approximately 1.5 hours of runtime. Charging time is approximately 3-4 hours for a full battery.

CLEANING THE FILTER

Flip the switch on the side of the vacuum to the OFF position.

Locate the bin at the back of the robot vacuum

Pull out the bin and open the top lid to dump out contents. You may use a small brush (sold separately) to gently clean the dustbin filter.

Note: Do not use the vacuum without the bin in place.

SPECIFICATIONS

• Battery: 7.4V 1800mAh Rechargeable Lithium
  Battery (Included)

• .5 Hours Battery Life Per Charge

• Charging Port: Micro USB (Cable Included)

• Cleans in Auto and Manual Mode

• Suction Power: 650PA

• Dimensions: 8.678.658.19 in

• Weight: 2.65lbs

• Remote Control Requires 2 x AAA Batteries (Not Included)

CHOKING HAZARD -Small parts, Not for children under 2 years. Use with adult supervision only

This symbol indicates that this product should not be treated as regular household waste. Please bring this item to an approved recycling collection facility for proper disposal.

© Smart Study Co., Ltd. All Rights Reserved. Pinkfong® and Baby Shark™ are
trademarks of Smart Study Co., Ltd. © 2022 Viacom International Inc. All Rights
Reserved. Nickelodeon is a trademark of Viacom International Inc. “Baby
Shark” song arranged by Pinkfong and KizCastle, and performed by KizCastle,
Sarah Bock, Andy Degan, Finn Phoenix, and Bommie Catherine Han.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. (1)This device may not cause harmful interference.
   (2)This device must accept any interference received, including interference that may cause undesired operation.

2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions ,may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. if this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an autlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF exposure statement for Remote control:

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

RF exposure statement for Robot Vauum:

This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>