MINKA LAVERY 2533-695 Spyglass Terrace Pendant Instruction Manual
- October 30, 2023
- MINKA LAVERY
Table of Contents
MINKA LAVERY 2533-695 Spyglass Terrace Pendant Instruction Manual
PREPARATION (Fig. 1)
1. Shut of power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
ASSEMBLING THE FIXTURE WITH CHAIN LOOP (Fig.1 &Fig. 3)
3. Secure rod (J) onto all thread (I) on the fixture body.
4. Determine the desired hanging height and thread rods (F1, F2 and F3) to the all thread on rod (J). Screw loop (H1) to rod (F1). Pass the wires carefully through each rod as you assemble.
5. Attach quick link (G) to loop (H1) and loop (H2) on canopy (D). Carefully feed the wire through loop (H1), quick link (G), and loop (H2).
6. Attach mounting plate (A) to the junction box (not included) with mounting screws (B) (Size: #8-32N*L0.5″). The side of the mounting plate with “GND” marked on it and two convex points must face out.
7. The support cable is provided to support the weight of the fixture while wiring. Align the fixture to mounting plate (A) and attach hook (P) on the end of support cable (C) and a slot located on mounting plate (A). Carefully allow the support cable (C) to support the weight of the fixture while wiring.
CONNECTING THE WIRES (Fig. 2)
8. Connect the electrical wires as shown in fig 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using the green screw provided.
9. Tuck the wire connectors neatly into the junction box.
COMPLETING THE INSTALLATION (Fig. 1)
10. Slide canopy (D) over mounting plate (A) and secure with screws (E).
11. Install (3) three medium base bulbs (K) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification–DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
Your installation is now complete. Return power to the junction box and test the fixture.
Note : Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
a. Hardware Bag:
A. Mounting Plate 1
B. Mounting Screw2
D. Canopy 1
E. Screw2
G. Quick Link1
H. Loop2
b. Hardware Bag:
F1. ROD 12″1
F2. ROD 12″2
F3. ROD 6″*1
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>