TDC 22524 5 Piece Steel Dining Set Instruction Manual
- June 3, 2024
- TDC
Table of Contents
TDC 22524 5 Piece Steel Dining Set
WARNING!
- Keep all children and pets away from the assembly area. Children and pets should be supervised when they are in the area of product construction.
- Some parts may contain sharp edges. When assembling and using this product, basic safety precautions should always be.
- Please read all the instructions and warnings before assembling. In order to make the whole product adjust to the best, please install all the screws on the product and tighten all the screws after adjusting the product it can stand on the floor even. Not intended for commercial use.
- Check all bolts for tightness before use.
- IMPORTANT – check and tighten bolts often to keep them secure
- CHOKING HAZARD-Small parts. Not suitable for children under 36 months. The product contains small parts, keep children away when assembling.
- ADULT ASSEMBLY IS REQUIRED. Always remove protective material and poly bags and dispose before assembly
Table Parts
Table Instructions
Step 1:
Place Table Top (A) on ground and open out.
Step 2:
Once Table Top (A) is open and upside down on the ground. Insert two Bolts
M6x15 (BB) through the top of Table Leg (B) and into the screw-threading of
table rim; do not tighten bolts all the way until assembly is completed.
Follow these steps to secure the remaining three Table Legs (B) to Table Top
(A).
Step 2:
Place Support (C) within groves of all four Table Legs (B). Insert two Bolts
M6x25 (AA) through holes on the inside of Support (C) and into the screw-
threading found at the center of each Table Leg (B). Tighten all bolts left
loose throughout assembly process using Hex Key (XX).
Step 3:
Turn the table right-side up. Place Cap (D) in the center of Table Top (A)
when an umbrella (sold separately) is not in use.
Chair Parts (x4)
Chair Instructions (x4)
4 Chairs are included in this set
Step 1:
Insert two Bolts M6x20 (AA) through each of the back-corners of Chair Seat
(B1) and into the screw-threading found on the legs of Chair Back (C1); do not
tighten bolts all the way until assembly is completed.
Step 2:
Place Armrest (A1) on the left side of previously assembled parts and Armrest
(A2) on the right. Insert two Bolts M6x20 (AA) through each of the front
corners of Chair Seat (B1) and into the screwthread found on the legs of
Armrests (A1 & A2); do not tighten bolts all the way until assembly is
completed.
Step 3:
Insert two Bolts M6x20 through holes found underneath armrests of A1 and A2
and into the screw-threading found on the sides of Chair Back (C1). Tighten
all bolts left loose throughout the assembly process using Hex Key (XX).
Follow these steps to assemble the remaining chairs for this set.
Step 4:
Place Cushion (D1) on the chair seat once finished with the assembly of
chairs.
Dist. by TDC USA, Inc. Fairfield, NJ 07004
©2022 All Rights Reserved. Made in China.
Item #22524
Questions and Comments
1-800-599-8898 (9 am – 5 pm EST)
www.tdcusainc.com
Made in China
The owner’s manual contains important safety information as well as assembly,
use and maintenance instructions. Keep the packaging and bags away from
children and dispose of all packaging properly before use. Keep this manual
for future reference.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>