PETLIBRO PL-WF115-01W Dockstream Stainless Steel 2.5L Cat and Dog Drinking Fountain User Manual
- October 30, 2023
- PETLIBRO
Table of Contents
Model: PLWF115
Dockstream Battery-operated
Automatic Pet Water Fountain
Bafora ising the product, please read this maeual themughhy and ratain it far Futura reteeenca.
SAFETY PRECAUTIONS
Warning
- Dispose of all packaging materials properly. Keep the polybags away from children and pets as these bags could cause suffocation.
- Do NOT allow children to play with, in or around the pet water fountain.
- To avoid injury, please keep close supervision when the appliance is used near children.
- Do NOT use the water fountain with pets not able to reach the water tray or with any physical disability.
- Do NOT place any foreign object in the water tank.
- Do NOT disassemble the pet fountain other than com-ponents as instructed in this User Manual.
- Do NOT use the pet fountain for anything other than its intended use.
- Only use attachments recommended or sold by the manufacturer. The use of attachments not recommend-ed or sold by the manufacturer may cause an unsafe condition. Do NOT modify the pet fountain.
- Do NOT operate any appliance if the unit is malfunc-tioning or has been damaged. Do not attempt repairs on the device yourself. Contact our customer service immediately for further instructions.
- Be sure to disconnect the power supply for safety when the appliance is not in use.
- Please disconnect the power supply before maintaining and cleaning the machine.
- Always unplug the appliance when not in use; or before putting on or taking off parts and before cleaning
- The power adapter and wire plug must not be flooded during cleaning.
- This product is for indoor use only.
- This product is not allowed to run without water
- Never pull the electrical power cord to remove the plug from the wall outlet.
- If the plug of this device gets wet, turn off the electricity of that wall outlet. Do NOT attempt to unplug
- Check the device after installation. Do NOT plug in if there is water on the contact points or plug.
- To avoid tripping, always position the power cord out of the way of foot traffic.
- Do not use the appliance in the bathroom.
- Replace the filter at least once every 2 weeks or when the flow rate has noticeably reduced. For two or more cats, you may need to replace the filters more regularly if it becomes blocked.
- In the whole machine, only the stainless steel part and the non-detachable part connected with it can be put into the dishwasher for cleaning. DO NOT put other parts into the dishwasher, otherwise, there is a risk of deformation.
CAUTION
- Do NOT allow pets to chew on or swallow any pans. If you are concerned about the power cord, purchase a cord conduit (a hard-plastic protector) at any hardware store to protect the power cord.
- If an extension cord is necessary, one unit with a proper rating should be used.
- Do NOT install or store the pet water fountain where it will be exposed to weather or temperatures below 0°C / 40°F.
- Read and observe all important notices listed on the pet water fountain and in the packaging.
This device complies with Part 15 of the FCC Rules. Oper-ation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired opera-tion.
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’ s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class 8 digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
inter-ference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit differ-ent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV techni- This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or trans-mitter.
Radiation Exposure Statement
To maintain compliance with FCC’s RF Exposure guide-lines, This equipment
should be installed and operated with minimum distance of 20cm from your body.
WARRANTY
- 1-year warranty
- Lifetime support
For guidance on product use and warranty extension, please contact our brand after-sales staff via email: support@pethbro.corn If any questions related to orders, please contact the seller through the shopping platform.
PRODUCT OVERVIEW
-
Spout
-
Filter Lid
-
Filter
-
Stainless Steel Water Tray
Note: Components 4 and 5 are Integrated and cannot be detachable. -
Filter Tray
-
Water Pipe
-
Foam Filter
-
Wireless Water Pump
-
Snap Lids
-
Water Tank
-
Power Cord
-
Power Adapter
-
Tank Base
Note: Components 9 and 10 are Integrated and cannot be detachable.
WORKING MODE INTRODUCTION
Power supply mode:
- Use of external power supply: the external power cord is required during use, which is suitable for use in areas with power sockets.
- Battery-operated use: there is a built-in rechargeable battery, which can be used without plugging in. It is suitable for indoor areas without power sockets.
Note: when used for the first time, it needs to be fully charged before
use If you need to use it immediately, you can connect the external power
cord, charge the water fountain while working, and then unplug it when it is
fully charged.
Water outlet mode:
- Regular Mode(This mode is only supported when external power is connected): 24 hours continuous water outlet.
- Induction Mode(This mode is only supported when battery powered):
- The water fountain has a built-in sensor, and when the pet activity is detected within the sensing range, it will automatically give water for 17 seconds.
- Induction Angle: 180° (including three sides, front, left and right sides).
- Sensing range (for pets): up to 80cm on three sides(100% induction within 30cm).
- After the induction mode is turned on, the machine will automatically water out for 17 seconds every hour to attract pets to drink water.
Note: The back of the water fountain cannot sense pets, so it is
necessary to use the back of the product against the wall to avoid affecting
pets drinking water.
HOW TO USE
-
Soak the filter in a clean bowl for 5 minutes, then rinse the filter thoroughly with tap water.
Notes:
1)The filter must be fully soaked before the fountain is turned on; otherwise, the water may not flow through the filter smoothly and cause spillage.
2)Do not soak the filter in the water tank of the fountain in case of any surface dust. -
Insert the foam filter into the groove of the water pump. Position the pump according to the bottom slot shape.
Note: Please pay attention to aligning the recessed part of the pump with the protruding part of the water tank, otherwise the pump cannot be installed firmly. -
Install the silicone pipe on the pump. Add water to the tank.
-
Install the water tray and fasten the snap lids.
Note: Pass the water pipe through the hole of the water tray, and the snap lids of the water tray need to be fastened, otherwise it will loosen. -
Install the soaked filter.
Note: Please make sure the hole of the water pipe passes through the hole of the filter. -
Inset!l the filter lid. Whether to install the spout depends on your pet’s drinking preference.
-
Power the water fountain.
- During external power supply:
Connect the power supply to the base.
o..) Turn on the power switch of the base. - During Battery-operated use: turn on the power switch of the base directly.
- Install the water tank with the tank base by aligning the protruding hole of the water tank with the tank base.
INDICATORS AND BUTTONS OVERVIEW
Lighting Part:
Battery Indicator
-
Breathing white:
the external power supply is being charged. -
Steady white: the battery is fully charged.
-
Flashing red(on for 1s and off for 4s)
: the battery is low and needs to be charged.
Off state: battery power is sufficient. The current battery power exceeds the
low power warning.
Water Tank Capacity Indicator
-
Off state:
the water tank capacity is sufficient, and the water is locat-ed above the lowest water level. -
Flashing red(on for 1s and off for 4s):
water in the tank is insufficient, need to add water.
Power Indicator
Power on: the white light flashes 3 times and then goes off.
Power off: the light remains off.
Note: The power indicator is hidden in the bottom case.
Button Part:
Power on : press the button, the button locked and the product is powered on.
Shut down : press the button again, the button is unlocked and the product is powered off.
BATTERY PCAK
The water dispenser has a built-in rechargeable battery, please pay attention to the following items in daily use:
- The built-in battery cannot be disassembled. Please do not disassemble it by yourself to avoid a decline in battery performance or damage to the battery. In serious cases, electrical safety hazards overheating, fire or injury may Occur.
- If the product has not been used for a long time, please charge the product at least once every six months to avoid affecting the service life of the battery.
- When low power is prompted, please charge the battery as soon as possible to avoid affecting the service life of the battery.
- Avoid using it at low temperature, otherwise, the battery power will decrease, which is a normal phenome-non.
- Please use the power adapter in the package to charge the water fountain.
- DO NOT expose the battery to any direct heat source, including fire or direct sunlight.
- The battery must be removed from the water fountain before it is scrapped.
- DO NOT dispose of the water fountain or the Battery Pack in fire, water or other liquids. This is to avoid any explosion hazards.
- DO NOT dispose of the Li-ion battery in your house-hold waste. Dispose of it by following your local environ-mental laws and regulations.
- Do not heat above 140 ° F )60 ° C) or incinerate the battery pack. Keep the battery pack away from children.
CARE INSTRUCTIONS
- Replace the filter and the foam filter at least once every 2 weeks.
- Clean the pump and fountain at lease once every 2 weeks.
How to clean the pump
-
Remove the foam filter, pump cover and impeller cover in sequence.
Note: The foam filter affects the water yield very much, so please clean it frequently and replace it in time when cleaning the pump. -
Remove the impeller by the brush hook.
-
Use the brush to clean the parts with water.
Tip: The brush can also be used to clean the spout. Recommended to clean the spout every 2 weeks.
TROUBLESHOOTING
Problem | Solution |
---|---|
Water keeps spilling out of the water tray. | The filter may not be fully |
soaked. Please soak the filter in a clean bowl (not in the water tank) for 5
minutes before the first use.
The pump stops working.| 1)Fill in water between MIN and MAX. The pump will
fail if it runs dry.
2)Clean the pump, water tank, and drinking basin.
3)If the above solutions don’t work, please contact us at
support@petllbro.com
How often should I change the filters? Where to get them?| Please replace the
filter at least once every 2 weeks.
support@petfibro.com to purchase new filters.
Why do I need to soak the filter before first use?| The filters absorb more
water (and therefore clean more water) when they’re wet and expanded. Soaking
the filter removes particulate matter that may have settled on the filter.
Water output speed slows down.| 1)For the first use (or reuse after long-time
storage), the water pump needs to discharge air, it’s normal if the water
output speed slows down.
Water output speed slows down.| 2)It is dirt in the pump, please refer to ‘How
to Clean the Pump” in the manual to clean it.
No water after installation| This product adopts a wireless pump, and the
power supply mode of the water pump is induction power supply. Please ensure
that the power supply is connected, the water tank and base are installed
correctly, and the water pump and water tank are installed correctly. Please
refer to the “How to Use” section of the manual.
Black residues and dirt appear in the water tank and on the filter element|
1)Please ensure that dean water sources are replaced regularly.
2)Please make sure to soak and wash the filter element in advance.
The battery is not charging.| Please do not disassemble the base and battery
by yourself. If the original adapter cannot be used for charging, please
contact us at support@petllbro.com
SPECIFICATIONS
Model | PLWF115 |
---|---|
Power Adapter | Input: 100-240V 50/60Hz Output: 5V/1A |
Material | ABS |
Water Tank Capacity | 2.5 L |
Battery Capacity | 5000mAh |
Battery Type | Li-Ion Battery Pack |
Dimensions | 226x187x161 mm / 8.9×7.4×6.3 inch |
Net Weight | 990g / 2.18Ibs |
PETLIBRO
Dockstream Battery-operated Automatic Pet Water Fountain
Model: PLWF115 ©Libro Corp. All Rights Reserved.
Manufacturer: Shenzhen Libro Technology Co., Ltd.
Address: 12/F, Tower B, GALAXY WORLD, Yabao Road, Longgang District,
Shenzhen, China
JP Importer: ISAatta
Made in China
PLWF115_V1.0 FCC ID: 2A3DE-PLWF115 CAN ICES-3 (B)/NMB-3(B)
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>