TOOLOTS XCD-90B Changing Door Hinge Instruction Manual

TOOLOTS XCD-90B Changing Door Hinge

The XCD-90B refrigerator door hinge can be changed from left to right hinge. The following instructions explain the process for changing the door hinge:

Part List

• A: Upper right hinge
• B: Left handle assembly
• C: Right trim panel
• D: Fixing the screw of the upper left hinge
• E: Right handle assembly
• F: Left trim panel
• G: Decoration box
• H: Handle lock of the control panel
• I: Left lower hinge
• J: Right lower hinge

Instructions

1. Remove the fixing screw of the upper left hinge D and remove the door.
2. Remove the right handle assembly E and left trim panel F of the door. Then install the corresponding left handle assembly B and right trim panel C of the door. Put the door in place for subsequent installation.
3. Remove the decoration box G and handle lock H of the control panel. Then install them to the corresponding position on the other side of control panel.
4. Install the upper right hinge C onto the right side of the cabinet.
5. Put the cabinet down. Remove the left lower hinge I and right lower hinge J.
6. Place the door with replaced handle and trim panel onto the cabinet. Install the lower left hinge I and the lower right hinge J after the door is put in the center of the cabinet. Do not forget to install the nylon gasket on the hinge shaft, otherwise, the door will be sagging.
7. After installing the door, stand the cabinet up. Then check whether the door handle and lock fit properly and whether the door seal is tight. The replacement of the door hinge is completed if there is no problem with the above inspection.

Note: The above instructions are provided for changing the door hinge of XCD-90B from the left to the right hinge. The process of changing the door hinge from right to left hinge will be the reverse of this process.

Operation instruction for changing the door hinge of XCD-90B (changing from left to right hinge)

1. Part list required to change the door hinge
   • A: upper right hinge
   • B: a left handle assembly
   • C: right trim panel
2. Remove the fixing screw of the upper left hinge
   • D: and remove the door
3. Remove the right handle assembly
   • E: and the left trim panel
   • F: of the door. Then install the corresponding left-handle assembly
   • B: and the right trim panel
   • C: of the door. Put the door in place for subsequent installation.
4. Remove the decoration box
   • G: and the handle lock
   • H: of the control panel. Then install them to the corresponding position on the other side of control panel.
5. Install the upper right hinge
   • C: onto the right side of the cabinet.
6. Put the cabinet down. Remove the left lower hinge I and right lower hinge J.
7. Place the door with replaced handle and trim panel onto the cabinet. Install the lower left hinge
   • I: and the lower right hinge
   • J: after the door is put in the center of the cabinet. Do not forget to install the nylon gasket on the hinge shaft, otherwise, the door will be sagging.
8. After installing the door, stand the cabinet up. Then check whether the door handle and lock fit properly and whether the door seal is tight. The replacement of the door hinge is completed if there is no problem with the above inspection.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>