GADGETMONSTER GDM-1050 RC Shark User Manual

October 30, 2023
GADGETMONSTER

GADGETMONSTER GDM-1050 RC Shark User ManualGADGETMONSTER GDM-1050 RC
Shark

Open the package and take out the product.

Opening take out the product
Attach the antenna.
Attaching the antenna.
Open the battery compartment with a screwdriver, insert the batteries. Tighten the screws.

Installation the battery

Charging

Charging the product

To charge the shark: On the remote controller change the switch to “on”. On the side of the remote control open the charge lid. Pull out the charge cable. Insert the charge cable into the charge port in the mouth of the shark. A LED turns on to confirm that it is charging. The LED turns off to confirm it is fully charged. The shark is  ready to be used.
controller Instruction
Pull out the antenna on the remote control. Change the switch to “on” on the remote control. Put the shark into the water. Do not place your hands near the tail of the shark, while it is moving. Make sure there are no obstructions on the shark tail. When you are done. Take the shark out from the water and wipe it with a dry cloth. 1. Electric contacts. When it is removed from water, the contacts will lose connection and the shark will stop moving.

Remote control

  1. Forward
  2. Power switch (on/off)
  3. Function LED
  4. Antenna
  5. Charging LED
  6. Decorative button
  7. Right turn
  8. Left turn

Remote control Instruction

The function LED will turn on when you press any button.
Press forward (1.), to make the shark go forward.
Press forward (1.) + right (7.) or left (8.) to make the shark turn right or left.

Troubleshooting

If there is water inside the product, it may help to open it up and dry it. For example, with a blow dryer. Close it properly after drying.
Troubleshooting
Warning instructions General warnings

  1. For ages 8 years and up.

  2. Choking hazard. Contains small parts.

  3. Save these instructions for future reference.
    Warnings (built-in battery)

  4. Do not recharge the built-in battery immediately when it is exhausted, instead wait until it cools down  before charging. Warnings (the remote control’s batteries)

  5. Batteries should be replaced by an adult.

  6. Only use recommended batteries.

  7. Batteries should be installed with correct polarity.

  8. Never mix different types of batteries, or new and used batteries.

  9. Never try to recharge non-rechargeable batteries.

  10. Always remove rechargeable batteries from the remote control before recharging them.

  11. Rechargeable batteries must only be recharged under adult supervision.

  12. Remove exhausted batteries immediately and replace them with new batteries of the same type. Recycle exhausted batteries according to local regulations.

  13. Do not short-circuit the battery terminals. When charging, keep the battery and charger away from reach of children.

Disposal of electric and electronic devices EC Directive 2012/19/ EU This product is not to be treated as regular household waste but must be returned to a collection point for recycling electric and electronic devices. Further information is available from your munic- ipality, your municipality’s waste disposal services, or the retailer where you purchased your product.
SIMPLIFIED EU DECLARATION OF CONFORMITY
The simplified EU declaration of conformity referred to in Article 10(9) shall be provided as follows: Hereby, DistIT Services AB declares that the radio equipment type  wireless device is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.aurdel.com/compliance/

DistIT Services AB, Glasfibergatan 8, 125 45 Älvsjö, Sweden
Suite 89, 95 Mortimer Street, London, W1W7GB, England

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals