Rexel 4050S Set Screw Connector Instructions
- October 30, 2023
- Rexel
Table of Contents
Rexel 4050S Set Screw Connector
MACHINE INTRODUCTION
TRANSFER PARAMETERS
| Platen Size | Platen Size | Voltage | Power | Time Range | Temperature |
|---|---|---|---|---|---|
| (CM) | (Inches) | (V) | (KW) | (Sec) | Range(°C) |
| 40 x40 | 16″ X 16″ | 110 | 2.5 | 0-999 | 0-299 |
| 40 x50 | 16″ X 20″ | 110 | 3 | 0-999 | 0-299 |
| 40 x60 | 16″ X 24″ | 110 | 3.8 | 0-999 | 0-299 |
NOTICE
- Use the heat transfer press only as intended
- Please keep children away from the machine
- Make sure the correct outlet is before use the device
- Burns can occur from contact with a hot surface
- Turn off the device when not in use and remove the power plug
Troubleshooting
Q: When pressed onto the garments, the color of the design is faded, or
transfers are not fully stacked onto the garments.
A: The reason comes from three points, the pressure is no enough, the
temperature is not hot enough or the design has not been pressed for enough
time. You may need to try more to get the right temp, time, and pressure.
Q: The transfers are stacked on the heating platen.
A: Transfers like dark ink-jet transfer paper could be stacked on a heating
platen, you should use a Teflon to cover the transfer paper.If this happens,
please turn off and cool the machine completely before you try to peel the
stacked paper, do not use sharp items like knives to scrape the heating plate
as Teflon may be scratched.
Q: Hard to peel off the transfer paper or vinyl.
A: Please make sure transfers are warm peel or cold peel, so as to peel off
accordingly.
Q: How to get reasonable pressure?
A: Adjust the pressure now and try to lock down the handle, feel there is a
certain large resist force.
Q: Turn on the power, but the heat press does not work.
A: Pls check the power plug connected well to the socket, you may turn to the
support team if the problem is still remains
- Set recommended TEMP, TIME, COUNT
- Wait for heat press heats up to the set temperature, the fire icon shows heating now.
- Let down the heating platen and start the heat pressing.
- Position the substrate and preheat to remove the wrinkles or moisture, continue to place the graphics design on paper or vinyl on the substrate, and cover with a Teflon sheet.
- Place the T-shirt with Teflon sheet and go for another 8 sec. heat pressing, then finishes the transfer!
- Take off the T-shirt and peel off the vinyl or paper depends on cold peel or hot peel.
- After ten thousands of swing-away and press, maybe you need to adjust the position screw on the back column to make sure the upper heating platen and lower plate is always paralleled. (For Air Pro One and X)
- It’s ordinary if you feel some drag force when you slide out or slide back the lower platen, as Magnetic Tech is applied, which makes sure the lower platen won’t slide back when you are threading a T-shirt, also makes sure upper & lower platens are in correct location after you slide the drawer back.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>