SIGURO SGR-FN-S470W Stand Fan User Manual
- October 30, 2023
- SIGURO
Table of Contents
SGR ‑FN ‑S470W
Stand Fan
User Manual
Translation of the operating instructions from the original language.
THANK YOU FOR YOUR TRUST
Thank you for purchasing a SIGURO appliance. We are grateful for your trust and we are pleased to introduce the device to you on the following pages and acquaint you with all its functions and uses.
SAFETY INFORMATION
Please read this manual carefully before use and keep it for future reference.
-
This appliance is intended for use by children 8 years of age and older and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, provided they have been given supervision or instruction in the use of the appliance in a safe manner and understand the potential hazards. Children must not play with the device. Cleaning and user maintenance must not be performed by children without supervision.
-
Make sure that the power cord or extension cord cannot be accidentally pulled out of the socket during operation.
-
Carry the appliance only by holding the body of the fan.
-
Make sure that the voltage in your outlet corresponds to the voltage indicated on the type plate of the appliance and that the outlet is properly grounded.
-
Never use the appliance if the power cord is damaged, if the appliance has fallen on the ground or is not working properly.
Have all repairs, including the replacement of the power cord, carried out by a specialist service! Do not remove the protective covers of the device, there is a risk of electric shock! -
Protect the device from direct contact with water and other liquids to prevent electric shock.
-
Do not use the appliance outdoors or in a humid environment or touch the power cord or the appliance with wet hands. There is a risk of electric shock.
-
Do not use the appliance in the immediate vicinity of places where heat accumulates (near the stove, heater, etc.).
-
Pay extra attention when using the fan near children!
-
Place the fan out of reach of other objects so that you ensure free air circulation that is needed for it proper operation. Never cover the fan openings!
-
Do not use this fan with a programmer, timer, stand ‑alone remote control system, or any other device that automatically switches the fan, since there is a risk of fire if the fan is covered or incorrectly positioned.
-
Never place the fan on soft surfaces such as a bed, sofa, etc. It must be placed on a stable and level surface.
-
If the appliance emits an unusual odour or smoke, unplug it immediately and take it to a service centre.
-
Do not switch the appliance on and off by inserting or removing the plug. Always switch off the fan with the main switch first, then you can unplug the power cord!
-
We recommend that you do not leave the fan unattended with the power cord plugged in. Unplug the power cord from the AC outlet before maintenance. Do not pull the plug out of the outlet by the cord. Disconnect the cable from the outlet by grasping the plug.
-
The power cable must not touch hot parts or run over sharp edges.
-
Do not insert fingers or other objects into the fan openings.
-
This appliance is intended for household use only.
-
This appliance is not intended for outdoor use.
-
To prevent overheating, do not cover the fan.
-
The fan may only be used if it is properly and completely assembled, including the support base and the protective grille.
-
The manufacturer declines any liability for damage caused by improper use or failure to follow the instructions in this manual. Improper use or non ‑compliance with the instructions will void the warranty.
OVERVIEW
- Motor body with shaft
- Fan body with control panel
- Power cable
- Upper column
- Lower column
- Stand
- Rear fan grille lock nut
- Fan propeller lock nut
- Rear grille
- Front grille
- Remote controller
SPECIFICATIONS
| Dimensions (H × W × D) | 1317 × 409 × 409 mm |
|---|---|
| Weight | 5.9 kg |
| Power | 220–240 V ~ 50 Hz |
| Power consumption | 35 W |
| Powering the controller | 2× AAA batteries |
ASSEMBLY
- Secure the colums to the base by rotating clockwise.
- Place the rear grille on the motor body so that the protrusions in the motor fit into the corresponding hole in the grille. Secure the grille by tightening the it clockwise.
- Place the propeller on the motor shaft and secure it with a nut. ATTENTION: Tighten the propeller nut counter ‑clockwise.
- Place the front grille on the rear grille. For safety reasons, the two grilles must be secured together with clips on the sides of the grilles and fixed with a screw screwed into the hole in the bottom of the grille.
- Screw the fan body onto the column by turning it clockwise.
USE
- You can use the control panel on the body of the appliance or the remote control to control the fan. The buttons for both controls and their functions are described below.
- Before using the remote control, you must insert in it two AAA batteries.
- Plug the power cord into the electrical outlet.
- The fan beeps briefly, indicating that the fan is ready for use.
- Turn the fan on/off by pressing the button on the remote controller or on the control panel.
Description of the control panel and remote controller
On/Off button
Speed setting button
Horizontal oscillation setting button
This button is also used to set the timer on the control panel.
Timer setting button.
Note: This button is located only on the remote controller
Rotation speed setting
To set the speed use the button . The fan contains 12 speed levels, which you
can switch between by pressing the button. If you hold down the button for a
longer time, the speed levels will move faster. The current speed level will
be shown on the display above
the control panel.
Timer function
This function allows you to set the time and when it elapses the fan will turn
off automatically.
Setting the timer using remote controller:
- Set the timer by repeatedly pressing the button on the remote controller.
Setting the timer using the control panel:
- Press and hold the button on the control panel. The fan is now in timer setting mode.
- Press this button repeatedly to set the desired value.
The timer can be set from 1 to 12 hours. „ “ setting means that the timer
function is off. If the timer function is active, the symbol on the display
will light up.
Horizontal oscillation
Turn the horizontal oscillation of the fan motor on/off by pressing briefly
the button on the remote controller or on the control panel.
CLENING AND MAINTENANCE
- Unplug the power cord before cleaning the fan!
- Use soft dry cloth for cleaning. Do not use thinner, gasoline or other aggressive cleaning agents containing solvents.
- Make sure that no liquid enters the device.
- Protect the appliance from water and high humidity!
- Never immerse the fan in water.
- If the fan will not be used for a long time, it must be protected from dust and moisture. We recommend storing it in the original packaging.
- In the event of a malfunction or an unusual odor, disconnect the appliance from the power supply and have it checked by an authorized service centre.
- You can use a vacuum cleaner with a dust nozzle to clean the grilles.
- Check the rear fan grille once a week and use a vacuum cleaner to clean it.
- We recommend to keep the packaging for possible moving or storing the fan.
Alza.cz a.s., Janko Cova 1522/53, 170 00 Prague 7, Czech Republic
© 2023 Alza.cz a.s. All Rights Reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>