DOQAUS CP7 Digital Meat Thermometer User Manual

CP7 DIGITAL MEAT THERMOMETER
User Manual

Model: CP7
Please read the user manual carefully and keep it for future reference.

Diagram

1. /°C/F button
2. HOLD/CAL
3. RESET
4. Protective storage sheath
5. Magnetic
6. Battery cover
7. 304 stainless steel probe

Package Contents

Meat thermometer 1
Protective storage sheath 1
User manual 1
Temperature guide 1
Battery CR2032 (8V) *1 (already installed)

Function Buttons

1.07°C/°F
Click Once
Power ON/OFF
Press and Hold for 3s
Switch between °C
°F. Default unit: °F

AOLD / CAL

• Hold the current reading Click Once The result will be kept for 10s. The Hold function will auto turn off if no operation is performed for 10 seconds. If you click the  HOLD button again in 10 seconds, the hold function will be turned off.
• Calibration Press and hold for 3s First, mix 90% crushed ice and 10% water for 3 minutes, then press and hold the CAL button for 3S, the CAL will flash for 3  seconds, and then put the thermometer into the ice-water mixture to measure. The screen displays and flashes 32°F (0.0°C) three times to complete 32°F(0.0°C)  calibration. The thermometer will automatically save the settings and enter the normal display state.

Note

1. Only when the ice-water mixture is within the range of 32°F ~33.8°F (0°C~1°C), can the thermometer enter calibration mode; otherwise, the calibration mode will be  unavailable.
   That is: LCD displays ERR and flashes three times, the product automatically exits the calibration mode and enters the normal display state.

2. The measurement environment should be carried out at normal room temperature. During calibration, the probe should not touch the surface of utensils. Always place  the thermometer probe in a mixture of ice and water.

 / RESET
(Backlight) Click Once
The backlight will last for 10 seconds and it auto turns off after 10s; but if you click it again in 10 seconds, the backlight will be off.

• Reset Press and Hold for 3s
  Press and hold the button 3s in power on mode, the LCD screen will flash for 3s to restore the factory settings.

Specifications

1. Temperature Range: -58°F~572°F(-50°C~300°C ); if the temperature is below -58°F (-50°C) or above 572°F (300°C ), LL.L or HH.H will show on the display
2. 10-minute Auto-off feature
3. Resolution: 0.1°C/°F
4. Backlight time: 10s
5. Waterproof (Do not immerse the whole unit in any liquid)

Operation instruction of battery replacement

• When first using this thermometer, please remove the power insulation film at first. It is available for use after removing the insulation film.
• Steps to replace the battery:

1. Loosen the screw and open the battery cover (as shown in figure)
2. Press the battery to take it out (as shown in figure)
3. It’s available for use after installing new battery
4. Close the battery cover

Troubleshooting

• Won’t Switch on

• Replace battery

• LL.L or HH.H on the Display
  Temperature exceeds measurable range: -58°F~572°F (-50°C~300°C)

• How to Clean
  Flush it with tap water. Never flush it for over 3 minutes, otherwise, it will be damaged.

• Compatible with Grill, Oven or Fryer?
  Handheld use.

• Inaccurate Reading
  Probe Length: 4.7in(120mm), try to insert the probe into the center of the food.
  If the above operations don’t work, please contact support@dogaus.com for help.

Use & Maintenance

• Do not touch the stainless portion of the thermometer during or right after measuring temperatures since it will be hot.
• Do not place the unit in dishwasher or immerse in any liquid.
• Do not leave exposed to extremely high or low temperatures since this will damage electronic parts and plastics.
• Do not leave the thermometer inserted in food during cooking.
• Remove battery if stored for more than four months.
• This item carries an 18-month warranty against defects in either components or workmanship.
  Email: support@doqaus.com for technical or service support.

Correct Disposal of this product
This marking indicates that this product should not be disposed of with other household wastes throughout the EU.
To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.
To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling.

CAN ICES-3(B) / NMB-3(B)
MADE IN CHINA
Model:CP7
Manufacturer: Dongguan Baafi Electronic Technology Co., LTD
Room 402, Building 2, No.3 Yinson Road,
Pingxi, Dongguan, Guangdong ,CN

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>