UBIQUITI UISP Wave AP Micro Access Point Installation Guide

UBIQUITI UISP Wave AP Micro Access Point Installation Guide

Safety Notices (if appliable)

1. Read, follow, and keep these
2. Heed all warnings.
3. Only use attachments/accessories specified by the manufacturer. WARNING: Failure to provide proper ventilation may cause fire Keep at least 20 mm of clearance next to the ventilation holes for adequate airflow.

WARNING: To reduce the risk of fire or electric shock, do not expose this product to rain or moisture.
WARNING: Do not use this product in location that can be submerged by water.
WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.

R Electrical Safety Information (if appliable)

1. Compliance is required with respect to voltage, frequency, and current S requirements indicated on the manufacturer’s Connection to a

different power source than those specified may result in improper operation, damage to the equipment, or pose a fire hazard if the limitations are not followed.

V  2. There are no operator serviceable parts inside this equipment. Service should be provided only by a qualified service technician.

3. This equipment is provided with a detachable power cord which has an integral safety ground wire intended for connection to a grounded safety outlet.

U          a. Do not substitute the power cord with one that is not the provided

• approved type. Never use an adapter plug to connect to a 2-wire outlet as this will defeat the continuity of the grounding
  1. The equipment requires the use of the ground wire as a part of the

Z              safety certification, modification or misuse can provide a shock hazard that can result in serious injury or death.

1. Contact a qualified electrician or the manufacturer if there are questions about the installation prior to connecting the
2. Protective earthing is provided by Listed AC adapter. Building installation shall provide appropriate short-circuit backup
3. Protective bonding must be installed in accordance with local national wiring rules and

Radiation Exposure Statement

• This equipment should be installed and operated with a minimum distance 50 cm between the radiator and your
• This transmitter must not be co-located or operating in conjunction with any other antenna or

Operating Frequency (MHz): 2400 – 2483,5 5150 – 5350 5470 – 5725 5725 – 5875 57000 – 66000*

Read More About This Manual & Download PDF

References

• Ubiquiti - Compliance

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>