anslut 423-326 Spotlight Instruction Manual
- June 11, 2024
- anslut
Table of Contents
423-326 Spotlight
Instruction Manual
SAFETY INSTRUCTIONS
Read the Installation Instructions carefully before use.
Save these instructions for future reference.
-
The product is intended to be connected to 230V-50Hz. The electrical installation must comply with local regulations.
-
For indoor use only. To be installed in a ceiling, out of of reach. Do not use in bathrooms, or wash rooms etc.
-
The mains connection should be fused with a 6 A fuse.
-
Consult an authorized electrician if in doubt. Disconnect the power supply before electrical installation.
-
Make sure that the power supply cannot be switched on by mistake.
-
Do not use bulbs with more than the permitted output (see type plate) risk of overheating.
-
The product gets hot when in use. Leave the product switched off for at least 10 minutes before adjusting, cleaning or changing the bulb, otherwise there is a risk of burn injuries.
-
Handle glass parts with care. Clean with a dry cloth. Never use liquids or abrasive detergents.
-
The sticker below indicates the minimum free space round the product. No object should be placed closer than 0.5 m to the product.
-
Never modify the product in any way. Modifications can result in serious personal injury and void the warranty.
INSTALLATION
Spotlight with connecting wires and bulbs of Gu10 type.
Preparations
- Check that there are no concealed electric cables or conduits where the installation is to be carried out.
- Remove all the packaging material and check that all the parts are included. Follow these instructions when installing.
- Check that all screw connections and electrical connections are tightened before use. The product can be connected to a dimmer.
- Contact an authorized electrician for advice on a suitable type of dimmer.
Tools:
- Flat and crosshead screwdrivers.
- Drill and drills.
- Stripping pliers for electric wires.
Care for the environment!
Recycle discarded product in accordance with local regulations.