OttLite CS7QI00Z-UK LED Desk Organizer Lamp Instruction Manual

June 11, 2024
OttLite

CS7QI00Z-UK LED Desk Organizer Lamp

Instruction Manual

OttLite CS7QI00Z-UK LED Desk Organizer Lamp

LED Desk Organizer Lamp with Wireless Charging Stand

CONGRATULATIONS! You’ve purchased the finest in natural lighting technology with your new OttLite ® product.
PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration Form and return it today by mail, or register online by going to: OttLite.com/warranty
WARNING: To prevent electric shock, make sure the lamp is not plugged in until all steps are complete.
NOTE: THIS UNIT IS FULLY ASSEMBLED

  1. Remove lamp from packing, placing lamp body base (A) flat on a steady surface.

  2. Connect power adapter input (B) into connector (C) in the rear-bottom of the lamp.

  3. Plug the power adapter (D) into a standard household 230V outlet. Note: Only use with the supplied power adapter to avoid damage or fire.

  4. Power switch (E) is a “touch” switch that controls ON/OFF power, the LED brightness settings and the colour mode function of the lamp.

  5. To power the light, slightly touch the switch (E) to achieve the following:
    • Turn lamp “ON” to 1st brightness setting; touch the switch “once”;
    • for 2nd brightness setting; touch the switch “two-times”;
    • for 3rd brightness setting; touch the switch “three-times”;
    • to turn lamp “OFF”; touch the switch “four-times”.

  6. This lamp provides three colour modes. To adjust lighting colour mode slightly “press and hold” switch (E) for three seconds to switch light colour temperature mode; 2700°K, 4000°K, 5000°K.

  7. To reposition the light, hold the lamp base (A) steady and grasp either flex-neck (F) or shade (G) depending on needed adjustment. DO NOT FORCE the shade or lamp body outside allowable adjustable range as excessive adjustment may cause damage.

WIRELESS CHARGING INSTRUCTIONS:
Wireless charging requires a Qi-certified device. To determine if your device is Qi-certified, please visit the Wireless Power Consortium website.
To wirelessly charge a device, perform the following:

  • Place the device on the stand horizontally, face-up, and flat against the middle of the Qwireless charging icon (H). NOTE: Device will only charge when placed in the horizonta positon.
  • When the device is centered on the Qi wireless charging icon (H), a solid RED light (J) will come ON noting charging mode active. NOTE: If RED light is OFF this indicates thedevice is not charging. Your device should show charging is taking place.
  • Check charge level on your device periodically to determine when device is fully charged
    NOTE: Product DOES NOT provide any indication of when device is fully charged.

CAUTION! Device may become warm during charging. This is normal and part of the process. Charging times vary by device.
THIS LAMP CONTAINS a 5V, 2.1A USB output port (K) located on the bottom rear of lamp. USB port can charge items such as tablets, cellular phones, etc.

CAUTION! IF THE EXTERNAL FLEXIBLE CABLE OR CORD OF THIS LUMINAIRE IS DAMAGED, IT SHALL BE EXCLUSIVELY REPLACED BY THE MANUFACTURER OR ITS SERVICE AGENT OR A SIMILAR QUALIFIED PERSON IN ORDER TO AVOID A HAZARD.
CAUTION! THE LIGHT SOURCE OF THIS LUMINAIRE IS NOT REPLACEABLE; WHEN THE LIGHT SOURCE REACHES ITS END OF LIFE THE WHOLE LUMINAIRE SHALL BE REPLACED.

CAUTION: Any change or modification to product not expressly recognized by OttLite
Technologies voids OttLite’s responsibility for proper function of product.
POWER ADAPTER SPECIFICATION:
Input: 100-240 V~, 50/60 Hz, 0.9A
Output: 12V
2.5A with a Male DC Plug
Qi CHARGER SPECIFICATION:
Output: 5V
1A
The “Qi” symbol is a trademark of the Wireless Power Consortium. All phones with integrated wireless charging support “Qi”.
WARNING: FIRE AND ELECTRIC SHOCK HAZARD

  • Do not expose the charger to liquid, moisture, humidity, or rain. Do not use the charger near a bathtub, sink, sauna, pool, or steam room. Exposing of the charger to moisture could result in electric shock.
  • Do not drop, disassemble, open, crush, bend, deform, puncture, shred, microwave,incinerate, paint, or insert foreign objects into the charger. Such actions could result in electric shock.
  • Clean the charger only with a dry cloth
  • Do not expose the charger to extremely high or low temperatures
  • Do not expose the charger to sources of excessive heat, such as sunlight, fire, etc.
    Do not place the charger near open fire sources, such as gas burners, candles, or fireplaces, and avoid contact with direct solar radiation. Do not place any candles or other open-flame sources on the device. Make sure that the charger has sufficient ventilation.

ACCESSORIES AND SOFTWARE INFORMATION: It is recommended that the following accessories should be used: The product software version is 2250-V1.0. Software updates will be released by the manufacturer to fix bugs or enhance functions after the product has been released. All software versions released by the manufacturer have been verified and are still compliant with the related rules. All RF parameters (for example, frequency range and output power are not accessible to the user, and cannot be changed by the user. r After evaluation, the product satisfied with RED Directive RF exposure required while used 20cm away from the human body.
EU REGULATORY CONFORMANCE
Frequency bands and power (a) Frequency bands 110-205KHz. (b) Maximum radiofrequency power transmitted in the frequency bands in which the radio equipment operates: The maximum power for all bands is less than the highest limit value specified in the related Harmonized Standard. The frequency bands and transmitting power (radiated and/or conducted) nominal limts applicable to this radio equipment are as follows: TBD dBuA/m at 10m distance.

Disposal of Old Electrical & Electronic Equipment
This symbol on the product or on its packaging indicates that this product (including batteries) shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste.

For more detailed information about recycling of this product, please contact your local Council, your household waste disposal service or the shop or source where you purchased the product.

DECLARATION OF CONFORMITY

PRODUCT: W22FS LED Desk Organizer Lamp with Wireless Charging Stand MANUFACTURER: OttLite Technologies, Inc.
1715 N. Westshore Blvd. Suite 950, Tampa, FL 33607. USA
Declares CE marking in accordance with the following EU directives and normative standards.
Hereby, Ott Lite Technologies Inc. declares that the equipment type W22FS is in compliance with Directive 2014/53/EU.
working range: 110-205KHz
Transmitting frequency: TBD dBuA/m at 10m distance

DIRECTIVES: STANDARDS:
Low Voltage Directive 2014/35/EU EN 60958-1:2015
+A1:2021 Luminaires – Part 1: General requirements and tests
EN 60598-2-4:2018 General Purpose Luminaire; Portable Requirements
EN 62031:2020 LED modules for general lighting safety specifications
EN 62493:2015 Assessment of lighting equipment related to human exposure to

electromagnetic fields
EN 61347-2-11:2008| Lamp Control Gear – Part 2-11: Particular requirements for miscellaneous electronic circuits used with luminaires
EN 61347-1:2015| General and safety requirements for lamp control gear for use on D.C. supplies
EN 61347-2-11: 2001| General and safety requirements for miscellaneous electronic circuits used with luminaires
EMC Directive 2014/30/EU| EN 55015:2020| EMC for Luminaires
EN 61547:2009| EMC Immunity
EN 61000-3-2:2021| Current Harmonics
EN 61000-3-3:2021| Voltage Fluctuations
EN 62311:2020| Exposure Restrictions for EMF (0Hz – 300 GHz)
RED Directive 2014/53/EU| Saftey and Health (Article 3.1a)| EN 62311: 2020
EN 60598-1: 2021
EN 60598-2-4: 2018
EN 62368-1:2014+A11:2017
EMC (Article 3.1b)| EN IEC 55015:2019/A11:2020
EN 61547: 2009
EN 61000-3-2: 2019+2021
EN 61000-3-3: 2013_A2: 2021
ETSI EN 301 489-1 V2.2.3 (2019-11)
ETSI EN 301 489-3 V2.2.0 (2021-11)
Radio (Article 3.2)| ETSI EN 303 417 V1.1.1 (2017-09)

Tampa, December 2022
J. Custode
Quality Assurance

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

OttLite User Manuals

Related Manuals