Ubiquiti Access Reader Lite User Guide

: June 11, 2024
: UBIQUITI

Table of Contents

Ubiquiti Access Reader Lite
Package Contents
Installation Requirements
Sample Wiring Topology
Hardware Overview
Hardware Installation
Speciﬁcations
Electrical Safety Information
Limited Warranty
FCC STATEMENT
ISED Canada
Online Resources
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Ubiquiti Access Reader Lite

Ubiquiti-Access-Reader-Lite-product

Package Contents

Ubiquiti-Access-Reader-Lite-fig-1

Note: Each UniFi Access component and all third-party accessories are sold separately.

Installation Requirements

Phillips screwdriver
Ethernet cable, CAT5e or better

Sample Wiring Topology

Ubiquiti-Access-Reader-Lite-fig-2

Door Position Switch
Externally Powered Door Opener
Magnetic Lock

Hardware Overview

LED

Hardware Installation

Note: Determine the installation locations for each UA-Hub and door access reader. Cable runs for Ethernet should not exceed 100 meters; wire runs for lock cables should not exceed 45 meters.

Peripherals

Ubiquiti-Access-Reader-Lite-fig-4

UA-Lite

Ubiquiti-Access-Reader-Lite-fig-5 Ubiquiti-
Access-Reader-Lite-fig-6 Ubiquiti-Access-Reader-Lite-
fig-7

UniFi Access Controller

Ubiquiti-Access-Reader-Lite-fig-9

Speciﬁcations

UA-Lite

Dimensions| 94.91 x 40.00 x 31.10 mm

(3.74 x 1.57 x 1.22″)

Weight| 65 g (2.29 oz)
Mounting Options| Wall Mount
Networking Interface| 10/100 Mbps Ethernet
Max. Power Consumption| 6W
Power Method| 802.3af PoE
IP Rating| IP54
Buttons| (1) Reset
LEDs| White / Blue
Connectivity| Ethernet, BLE 4.1
Operating Temperature| -40 to 40° C (-40 to 104° F)
Operating Humidity| 5 to 90% Non-Condensing
Certiﬁcations| CE, FCC, IC
NFC

Frequency| 13.56 MHz
Read Range| <30 mm
Standards| ISO 14443A, 14443B, 15693
---|---
Technology| NFC Tag 1, 2, 3, 4, 5

MIFARE Classic MIFARE Plus MIFARE Ultralight

MIFARE DESFire EV1/EV2

Safety Notices

Read, follow, and keep these instructions.
Heed all warnings.
Only use attachments/accessories speciﬁed by the manufacturer.

WARNING: Do not use this product in location that can be submerged by water.

Electrical Safety Information

Compliance is required with respect to voltage, frequency, and current requirements indicated on the manufacturer’s label. Connection to a different power source than those speciﬁed may result in improper operation, damage to the equipment or pose a ﬁre hazard if the limitations are not followed.
There are no operator serviceable parts inside this equipment. Service should be provided only by a qualiﬁed service technician.

Limited Warranty

ui.com/support/warranty
The limited warranty requires the use of arbitration to resolve disputes on an individual basis, and, where applicable, specify arbitration instead of jury trials or class actions.

FCC STATEMENT

Changes or modiﬁcations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions.

This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

This radio transmitter (FCC ID: SWX-UALITE) has been approved by FCC.

ISED Canada

CAN ICES-3(B)/NMB-3(B)
This device complies with ISED Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

This device may not cause interference, and
This device must accept any interference, including interference that may cause undesired operation of the device.

This radio transmitter (IC: 6545A-UALITE) has been approved by ISED Canada.

IMPORTANT NOTE

Radiation Exposure Statement

This equipment complies with radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20 cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

CE Marking
CE marking on this product represents the product is in compliance with all directives that are applicable to it. Ubiquiti-Access-Reader-Lite-
fig-10