Seeed Studio BliKVM Plug Play Pcle Handbook Instruction Manual

June 11, 2024
seeed studio

Seeed Studio BliKVM Plug Play Pcle Handbook Instruction Manual
Seeed Studio BliKVM Plug Play Pcle Handbook

Product Overview

Product Overview

Unpack and take out the devices

Product List
Unpack and take out the devices

Install the main device

Install CM4 and 4 Hex spacers (This article takes CM4 lite as an example, using the image in the Micro SD card, CM4 eMMC user need to burn the image by yourself.)Stick a heat conductive sheet on the top of CM4 , tear off the protective film of the sheet.
Install the main device
Install the main device

The main device installation is complete.

Connect USB and ATX

The motherboard used in this article is Asus H520M-E, the interface definition of different motherboards may be different, please refer to your motherboard manual.
Connect USB and ATX
Connect USB and ATX

mother board Asus H510M-E Bilk- Pie Chassis Panel Switches and LEDs
1 LED PWR+ POWER LED+
2 LED PWR- POWER LED-
3 BIN PWR+ POWER SW
4 BTN PWR-
5 LED HDD+ HDD LED+
6 LED HDD- HDD LED-
7 BTN RST+ RESET SW
8 BTN RST-

Connect OLED

The OLED you received does not have a bracket installed. Please refer to the picture for installation. In addition, OLED support is made of acrylic material, which needs to be used after removing the protective film on the surface.
Connect OLED

Connect the HDMI cable

Connect the HDMI output port of the computer directly to the HDMI IN port of the product with an HDMI cable. The HDMI pass-through EDID emulator is not necessary! If your computer does not output the correct HDMI format, plug the HDMI pass-through EDID emulator into the HDMI output port of the computer. This allows you to configure a fixed HDMI output format on your computer.
Connect the HDMI cable

Connect the network cable

Gigabit Ethernet port standard: IEEE 802.3af Po E input voltage:37v-57v.
Connect the network cable

When using Po E power supply, there is no need to connect the PWR-IN port.

Connect PWR-IN

Connect PWR-IN

When not using Po E power supply, connect the PWR-IN port to a standard 5V/3A USB power supply.

Test

OLED screen showing device IP and other information.
Test

Access the IP address in browser. After passing the test, install the product into the computer case.

Install the product into the computer case

Disconnect power and wiring, install the product on the motherboard, and reconnect the cables after installation is complete. The color of ATX cable received in different batches may be different. Please directly refer to the pin definition for connection.
Install the product
Enjoy!
Appendix 1.Install a low profile PCIe I/O bracket

Note
Install a low profile
Install a low profile

Appendix 2.Install the cooling fan

Usually the metal heatsink is sufficient, the cooling fan is not necessary.
Install the cooling fan
Install the cooling fan
Install the cooling fan

The cooling fan is controlled by CM4 via GPIO12.

Appendix 3.Install wi fi antenna

Please note that not all CM4 versions come with wit) modules.
Install wi fi antenna

More

See https://wiki.blicube.com/blikvm/en/

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

seeed studio User Manuals

Related Manuals