Aerpro G182V High Level Brake Light Camera User Manual
- June 11, 2024
- Aerpro
Table of Contents
G182V High Level Brake Light Camera
User Manual G182V
G182V High Level Brake Light Camera
High Level Brake Light/Camera Mercedes Benz Vito 2016 >
PRODUCT FEATURES:
Image Sensor: 1/3″ CMOS
TV Lines: 700
Resolution: 976 x 592
Minimum Illumination: 0.1 Lux (0 Lux when LED’s on)
TV System: NTSC Infra-red
LEDS: Yes (8)
Waterproof Rating: IP68
Viewing Angle: 150
Degrees Video Output: 1.0V p-p 75ohm
Parking Guidelines: Yes (Removable)
Operating Voltage: 12V DC (Negative Ground)
Operating Temperature: -20 Degrees C to +70 Degrees C
DISCLAIMER:
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for
installation. Please ensure you use the correct tools to avoid damage to the
vehicle or product. Aerpro can not be held responsible for the installation of
this product.
Technical Support
Aerpro want to provide a fast and suitable resolution should you encounter any
technical issues. With this in mind, when contacting Aerpro, try to provide as
much Information as possible. This will speed up the process and help us to
help you. Please use our dedicated online technical support centre:
aerpro.com/contact
CONTENTS
- Camera with Male 4pin camera connector
- 10m Female 4pin to Male 4pin extension cable
- Female 4pin camera connector to 1x Yellow Female RCA and 1x Female DC power connector
- 1.5m DC power cable with Male DC connector to bare wires
- Male to Male RCA adapter
- Instructions
INSTALLATION
- Remove the third brake light from the vehicle and unplug the connection cable.
- Connect the G182V to the pre-existing connection cable and refit to the vehicle taking care not to trap any cables.
- Connect the 4pin of the extension cable to the camera and thread through the vehicle
- Connect the other 4pin connector on the extension to the 4pin connector found on the RCA/DC split wire.
- Use the DC power cable to plug into the black connector and proceed to wire the red to a source of 12V and black to a source of ground.
- Use the Male to Male RCA adpater to plug into the yellow RCA on the harness, and then plug this into the aftermarket accessory’s video input.
- Test the camera connection by turning on the ignition. The rear camera feed should now be visible on screen. Put the vehicle into reverse and the reverse camera feed will automatically populate on screen. If camera feed is unresponsive, please uninstall the wiring and reinstall carefully in accordance with the above steps
- The camera will be default with parking guidelines. To remove this, simply cut the green wire found on the camera’s connector.
For further help and support, please contact us directly at aerpro.com/contact and fill out a support ticket with the full details of your issue.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>