FlINQ FQC8276 Peak Sensor Bin Instruction Manual
- June 11, 2024
- FlinQ
Table of Contents
FlINQ FQC8276 Peak Sensor Bin Instruction Manual
Welcome to the FlinQ family
Thanks for purchasing one of our items! To ensure continuous operation and accuracy, please read these operating instructions carefully before use and save this manual for future use. Passing certain procedures may result in incorrect reading and incorrect use of this product. We hope that you will enjoy using your new FlinQproduct! If by any chance the item is damaged, defective or broken, you are covered with warranty! Please do not hesitate to contact us for any questions, concerns or suggestions at the email address as mentioned in this manual.
Register your FlinQ product
We can imagine you want to treat your FlinQ item carefully. Register your
product and you will be entitled to the following
- 1 year extra warranty (2+1)
- Personal support
- Digital warranty certifi cate
- Digital manual
Note: Please read the safety and assembly instructions carefully, in order to avoid the risk of any injury by using the product or damaging to the product.
Note: Read these instructions carefully and thoroughly. Keep these instructions to read through at a later date. If you give the product to anyone else at some point in the future, please ensure you also pass on this manual.
Note: Only for domestic use and not for commercial use!
Warning: Keep small parts, plastic bags and other packaging out of reach of children.
Pay attention especially when you unpack the item. Danger of suff ocation! Check the delivery for completeness. Later complaints cannot be accepted. Check all elements and parts for damages. Despite careful control, products may be damaged in transit. In this case, do not assemble your product. Defective parts can endanger your health.
Note: Never modify the product! Changes will void the warranty and the product may be unsafe or even dangerous.
Intended use
The automatic dustbin is designed to store household waste for a short period.
Comfortable and hygienic! The automatic trash bin works over a motion detector
automatically and also closes accordingly the garbage disposal. It is intended
exclusively for use in dry and enclosed areas. Use the product only for its
designed purpose of use. Manufacturer will not assume any responsibility in
case of damages caused by any unappropriated use. Any modifi cations applied
by the customer on the original product will have a negative impact on the
safety and the quality of the product, cause damage to it and will cancel the
warranty
Safety intructions
- Do not put anything on the lid, or push the trash bin under a low storage too (eg kitchen countertop). The lid must, whenever necessary, fully be opened. Failure to do so may result in any damage.
- Do not close the lid by hand, always use the automatic function to do so, or the manual button.
- For cleaning, please use a damp cloth to wipe the surfaces. Absolutely avoid to bring the electrical components in contact to water.
- Place the dustbin in a way there will be no direct sunlight on the sensor.
- Keep the trash bin away from open fire or hot surfaces.
- If the batteries are empty, always replace all the batteries at the same time. When inserting the batteries, place them in the correct polarization. To disposed the used batteries, please be aware of the local waste disposal directives.
Start-up and use
Remove the trash bin from its packaging. Packaging and foam material must be
disposed follow to local regulations. Open the lid of the battery compartment
and insert the batteries (4x 1.5V AA batteries, not included). Make sure the
right polarization is used. Please watch the + and – signs in the battery
compartment. The lid will open when it perceives movement about 20cm above the
sensor, over 0,5 seconds. And it will close again when the sensor notices no
movement for about 3 seconds within the same range of 20cm-range notes. ON/OFF
function: if you turn the battery compartment halfway back, the sensor
function will be switched off.
Care and storage
Check all the parts. If any problems are detected, do not use the product.
Always replace al parts with original replacements according to the
manufacturers guidelines. If the product is not properly cared for and
maintained, it may become unsafe and can also become damaged. This can lead to
dangerous situations. Improper handling of the waste bin can damage the
product.
- Make sure that no cleaning water will enter the battery compartment or touch the sensors of the lid.
- Do not clean the parts of the waste bin in the dishwater and immerse it under running water.
- For cleaning use a sponge and warm soapy water. Do not use solvent based cleaners or detergents for example bleach. These may damage the bin.
- Afterwards, please dry thoroughly with a soft cloth.
Meaning of buttons / specifications
- Bin body
- Cover
- Lid
- Sensor panel
- Battery compartment
- DC in jack (adapter not included)
- Low power alarm
- Manual operation button
- Sensor eye
Install the batteries
-
Batteries (not included)
-
Take out battery compartment
-
Place batteries
-
Place compartment back in
Manual operation
Open / close
Don’t press the lid
Change batteries
Avoid sunlight
Documents / Resources
|
FlINQ FQC8276 Peak Sensor
Bin
[pdf] Instruction Manual
FQC8276 Peak Sensor Bin, FQC8276, Peak Sensor Bin, Sensor Bin, Bin
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>