CENTEK CT-2156 Electric Shaver Instruction Manual

: June 9, 2024
: CENTEK

Table of Contents

SAFETY PRECAUTIONS
APPLIANCE DESCRIPTION
SCOPE OF SUPPLY
OPERATING PROCEDURE
CARE OF THE DEVICE
- CLEANING AFTER USING THE RAZOR
- CLEANING THE HEADS (AT LEAST 1 TIME PER MONTH)
SPECIFICATIONS
DISPOSAL
CERTIFICATION DATA, GUARANTEE
- MANUFACTURER AND IMPORTER INFORMATION
- GUARANTEE MAINTENANCETERMS
Documents / Resources

CENTEK CT-2156 Electric Shaver

CT-2156 Electric Shaver

Dear Customer,
Thank You for purchasing a CENTEK brand product. We guarantee flawless function of this item, provided the guidelines of its operation are observed.

The electric thermopot is a home appliance and is not designed for industrial applications!
PURPOSE OF THE APPLIANCE: for quality shaving of facial hair.

SAFETY PRECAUTIONS

The following requirements should be strictly observed in order to avoid situations hazardous for human life and health, as well as premature failures of the appliance

Read this manual carefully before putting the device into operation.
Keep these instructions, the cash receipt and the packaging of the device. In case of loss, the operating manual is not renewed, and such a device is removed from the warranty. Use the device only for its intended purpose.
Do not place the device near heat sources, do not expose it to direct sunlight and moisture (it is forbidden to immerse it in water and other liquids).
Do not touch the device with wet hands.
In case of moisture or leakage from the appliance, disconnect it from the mains immediately.
Do not install the device on soft, uneven, unstable surfaces. Do not cover the appliance.
Disconnect the appliance from the power outlet after use and before cleaning. When disconnecting the device, it is necessary to take and pull the plug, not the power cord.
Do not allow children to play with the appliance. Do not leave the appliance unattended. Make sure that the power cord is laid out of the reach of children.
This appliance is not intended for use by persons (including children) with reduced physical or mental capabilities, or who do not have sufficient experience and knowledge without instruction on the use of this appliance and on possible dangers in case of its improper operation.
Check the appliance and its power cord regularly for damage. Operation of a faulty device is not allowed. Do not attempt to repair the appliance yourself. Contact qualified specialists. If the power cord is damaged, replace it immediately by the manufacturer, authorized service or a qualified specialist.
It is allowed to use only original spare parts. Do not use accessories that are not included in the package.
Before starting operation, make sure that the mains voltage corresponds to the one indicated on the device.
Before turning on the device, make sure that it is fully and correctly assembled.
Do not pull the power cord if it touches the edges of objects with sharp edges, is squeezed by any objects or is tangled; do not allow the power cord to touch hot objects.
If the power cord or any other part of the device is damaged, immediately disconnect the device from the electrical network and contact the manufacturer’s service center. In case of unskilled interference with the device device or non-compliance with the rules of operation of the device listed in this manual, the warranty is canceled.
Connect the device only to power outlets that have a ground contact, use extension cords of only two-pole type 10 A with a grounding wire.
Do not use several energy-intensive devices at the same time, this may lead to malfunctions in the electrical network of residential premises.
The device can be disassembled only after the engine stops completely.
The appliance should not be used if:
• the power cord is damaged;
• the device has visible damage;
• the device fell from a height;
• moisture got on the device.
Do not use the appliance at temperatures below 0 °C and above 35 °C. If the device has been at a temperature below 0 °C for a long time, place it in a heated room at least 3 hours before switching on.
Should You decide to transfer the appliance to another person, please pass the present manual over along with it.
Packaging materials can be potentially dangerous for children and should be put away in a specially designated place.
Special conditions for transportation (transportation), sale: no.

ATTENTION! Danger of fire! Never allow the device to come into contact with flammable liquids and combustible materials.
ATTENTION! When using the appliance in the bathroom, it is necessary to disconnect the appliance from the mains after use, since the proximity of water is dangerous, even when it is turned off;

APPLIANCE DESCRIPTION

Appliance Description

Shaving Heads Unit
Electric shaver body
ON/OFF button
Charging indicator
Adapter socket

SCOPE OF SUPPLY

Electric shaver – 1 pc.
Power cord (USB Type C) – 1 pc.
Cleaning brush – 1 pc.
Operation manual – 1 pc

OPERATING PROCEDURE

Remove protective cap.
Charge the device before first use.
Connect the power cord to the electric shaver and connect to the power supply. The charging indicator on the device will light up.
The battery is fully charged in 1.5 hours.
It is not recommended to keep the shaver plugged in for more than 24 hours.
After charging is complete, unplug the power cord from the mains socket and shaver socket.
To turn on, press the «ON / OFF» button.

NOTE:

The product includes accessories for use with this appliance only. Accessories from other manufacturers are not replacements forthis product.

CARE OF THE DEVICE

CLEANING AFTER USING THE RAZOR

Regular cleaning of the device will ensure the best quality of shaving.
The most convenient and hygienic way of cleaning is to rinse the shaving unit razor and cameras to gather the hair with warm water after each use of the shaver.
Pry up the shaving unit cover, this will open the shaver unit to provide access for cleaning.
Using a brush, clean the shaving unit with internal and external parties, as well as drive the blades.
It is allowed to flush the shaving unit under a stream of warm water. Completely dry the shaving unit before closing it. Avoid getting water into the body of the electric shaver. After complete drying, close the shaving unit, put a protective cap on it and put the razor away for storage.

CLEANING THE HEADS (AT LEAST 1 TIME PER MONTH)

Detach the shaving unit.
Clean the knives and mesh heads with a brush from the razor kit.
Clean the heads one at a time, because they are individually fitted sets. If you accidentally mix up knives and nets, it may take several weeks to work on the knives and restore the effective operation of the razor.
Install the knives with nets in the shaving unit. Replace the frame holding the heads.
Make sure that the protrusions on the mesh heads fit into the cutouts in the block.
Install the shaving unit on the razor and close it.
For deeper cleaning, you can disconnect the shaving unit from the housing.

SPECIFICATIONS

Input voltage : 5V 1A
Power supply : Li-ion 500 mA battery
Power: 5 W
Battery charging time: 1.5 hours
Continuous operation time: up to 60 minutes

DISPOSAL

Upon expiry of its service life the appliance can be disposed of separately from ordinary domestic waste. You can turn it over to a specialized electric and electronic appliance disposal and recycling centre.

CERTIFICATION DATA, GUARANTEE

The service life of this item is 5 years since the date of sale to the end user, provided the item will be used in strict accordance with the present manual and the applicable technical standards. Upon expiry of the service life please contact the nearest authorized service centre for suggestions as to further operation of the appliance. The manufacturing date of the appliance is integrated into the serial number (digits 2 and 3 – year, digits 4 and 5 – month of manufacture).
If any questions related to appliance maintenance should arise, or if the appliance has malfunctions, apply to the CENTEK TM Authorized Service Center. The address of the service center can be found on the website https://centek.ru/servis. Service support contacts: Phone: +7 (988) 24-00-178, VK: vk.com/centek_krd. General Service Center: OOO «Larina-Servis», Krasnodar, Phone: +7 (861) 991-05-42.
The product is provided with the Certificate of Conformity No
ЕАЭС RU С-CN.НВ26.В.01825/21 of 28.12.2021.

MANUFACTURER AND IMPORTER INFORMATION

Imported to EAEU by: Individual niy Predprinimatel Asrumyan Karo Shurikovich. Address : Russia, 350912 Krasnodar, ul . Atamana Lysenko, 23, pgt. Pashkovskiy. Phone: +7 (861) 2-600-900.

DEAR VALUED CONSUMER!
The guarantee period for all appliances amounts to 12 months since the date of sale to the end consumer. With this Warranty Card the Manufacturer confirms the proper condition of the appliance and undertakes to repair, free of charge, al l defects caused by the Manufacturer’s default.

GUARANTEE MAINTENANCETERMS

The guarantee shall be valid if the following documentation conditions are observed:
• The original Warranty Card shall be filled out correctly and clearly, indicating the of appliance model, serial number and sale date, the stamp of the seller company and signature of its representative shall be available, as well as the stamps on each coupon and the buyer’s signature in the Warranty Card.
The Manufacturer reserves the right to reject guarantee maintenance if the buyer fails to provide the abovementioned documents or if the information contained therein is incomplete, illegible or ambiguous.
The guarantee shall be valid if the following operation conditions are observed:
• the appliance is used in strict accordance with the present manual;
• the safety rules and requirements are observed
The guarantee does not apply to regular maintenance, cleaning, installation and setup of the appliance at the owner’s location.
The guarantee does not apply in the following cases:
• mechanical damage;
• normal wear of the appliance;
• non-observance of operation requirements or erroneous actions on the part of the user;
• improper installation or transportation;
• natural disasters (lightning, fire, flood, etc.), as well as any other causes beyond the Manufacturer’s or Seller’s control;
• ingress of foreign objects, liquids or insects into the inside of the appliance;
• repairs or modifications to the appliance by unauthorized persons;
• use of the appliance for commercial purposes (loads exceeding normal domestic application), connection of the appliance to utility and telecommunication networks incompliant with national technical standards;
• failure of the following accessories, if replacement of these is allowed by design and does not involve disassembly of the appliance:
a) remote control units, rechargeable batteries, replaceable batteries (power cells), external power supply units and chargers;
b) consumables and accessories (packaging, covers, slings, carry bags, mesh screens, blades, flasks, plates, supports, grilles, spits, hoses, tubes, brushes, nozzles, dust collectors, filters, smell absorbers);
• for battery-powered appliances – operation with inappropriate or depleted batteries;
• for rechargeable battery-powered appliances – any damage caused by improper battery charging and recharging.
The present guarantee is provided by the Manufacturer in addition to the consumer rights determined by the applicable legislation and does not limit these rights in any way.
The Manufacturer shall not be made liable for possible damage, directly or indirectly inflicted by CENTEK brand products on people, domestic animals, the consumer’s or third persons’ property if such damage is inflicted as the result of non-observance of appliance installation and operation requirements, deliberate or negligent actions (omission) by the consumer or third persons, as well as of force majeure circumstances.
Service centers will only accept appliances in a clean state (there should be no food residues, dust and other contamination on the appliance).