Centek CT-2570 Vacuum Cleaner Instruction Manual

Centek CT-2570 Vacuum Cleaner

Specifications:

• Model: CT-2570
• Type: Vacuum Cleaner
• Battery Type: Li-Ion
• Battery Capacity: 2500mAh
• Input Voltage: 220-240V
• Power Consumption: 400-500W
• Dust Capacity: 180ml

Product Usage Instructions

Initial Setup:

1. Unbox the vacuum cleaner and remove all packaging materials.
2. Charge the Li-Ion battery fully before first use.
3. Attach the appropriate brush or accessory based on your cleaning needs.

Operating Modes:

The vacuum cleaner has three operating modes:

• ECO Mode: Suitable for regular cleaning tasks.
• STRONG Mode: Provides increased suction power for tougher dirt.
• MAX Mode: Delivers maximum suction power for deep cleaning.

Power Settings:

You can adjust the power settings as follows:

• 100% Power: Use for maximum cleaning performance.
• 50% Power: Suitable for general cleaning tasks.
• 10% Power: Use for light cleaning or conserving battery.

Cleaning and Maintenance:

Follow these steps to clean and maintain your vacuum cleaner:

1. Regularly empty the dust container to maintain suction power.
2. Clean the filters to ensure optimal performance.
3. Avoid vacuuming up liquids or large debris that may damage the unit.

FAQ

Q: How do I replace the filters?

A: To replace the filters, locate the filter compartment, remove the old filter, and insert a new one following the manufacturer’s instructions.

Q: Can I use the vacuum cleaner on hardwood floors?

A: Yes, the vacuum cleaner is suitable for use on hardwood floors. Use a suitable brush attachment to avoid scratching the surface.

DEAR CUSTOMER!
Thank You for purchasing a CENTEK brand product. We guarantee flawless function of this item, provided the guidelines of its operation are observed.

PURPOSE OF THE DEVICE
For cleaning dust and dirt from hard and soft surfaces (hard floor, carpet, etc.).
The vacuum cleaner is a home appliance and is not designed for industrial applications.

SAFETY PRECAUTIONS

The following requirements should be strictly observed in order to avoid situations hazardous for human life and health, as well as premature failures of the appliance:

1. Carefully read the present manual prior to operating the appliance. Retain the present manual, cash voucher and appliance packaging.
2. Before operating the appliance ensure that the power supply grid voltage corresponds to that indicated on the charger.
3. Connect the appliance for charging only to power grid sockets equipped with earthing contacts, use only two-pole extension cables with 10 A rating and an earthing conductor.
4. The appliance should be turned off during charging.
5. Never charge the cleaner at ambient temperatures above 37 °C and below 0 °C.
6. The charger may become hot during charging.
7. Always disconnect the charger from the electric socket after fully charging the battery. Pull the charger connector from the charger socket of the appliance before use and any cleaning and maintenance operations.
8. Do not leave the appliance near sources of heat.
9. Do not obstruct the air exhaust grille.
10. Do not use methyl alcohol and other solvents for cleaning the appliance.
11. Do not use the vacuum cleaner to collect liquids.
12. Only the use of original spare parts is allowed. Do not use accessories which are not included in the scope of supply.
13.  Do not turn the appliance on if it is damaged or malfunctioning.
14. Do not charge the appliance if its power cable or plug is damaged, if doesn’t run smoothly or has been dropped.
15. Do not attempt to repair the appliance yourselves.
16. If the charger is damaged it should be replaced by the Manufacturer, a service facility or other skilled personnel.
17. Do not submerge the appliance in water or any other liquids.
18. The appliance should not be used by physically, sensory or mentally handicapped persons (including children) or by persons without sufficient experience or knowledge, unless such persons are under supervision, or have been instructed on the use of the appliance, by the persons responsible for their safety. Take precautions not to children play with the appliance.
19. Special instructions for transportation (shipment) and sale: none.
20. Should You decide to transfer the appliance to another person, please pass the present manual over along with it.

APPLIANCE DESCRIPTION

1. Control panel
2. Intake НЕРА filter
3. Top cover
4. Cyclone dust collector
5. Outlet НЕРА filter
6. Aluminum tube
7. Cleaning tool
8. Electric floor brush
9. Operating mode indicators
10. ON/OFF button
11. Battery status indicators
12. Mode selection button

SCOPE OF SUPPLY

• Main housing – 1 pc.
• Flat attachment – 1 pc.
• Slot brush – 1 pc.
• Power adapter – 1 pc.
• Aluminum tube – 1 pc.
• Electric floor brush – 1 pc.
• Wall bracket – 1 pc.
• Self-tapping screw – 2 pcs.
• Dowel – 2 pcs.
• Intake HEPA filter – 1 pc.
• Outlet НЕРА filter – 1 pc.
• Cleaning brush – 1 pc.
• User Manual – 1 pc.

OPERATING PROCEDURE

ASSEMBLY

• Attach the aluminum tube to the main housing of the appliance.
• Insert the electric brush into the other end of the aluminum tube.
• Connect the power adapter to the appliance; plug the adapter into a 220- 240 V electric socket.
• Before the first use allow the appliance to charge for 5 hours, then operate the appliance to fully discharge the battery. For further use the normal battery charging time will be 4 hours.
• When the battery is charged disconnect he power adapter from the electric socket.
• Fasten the wall bracket to a wall using the self-tapping screws and dowels included in the supply.

USING THE ASSEMBLY AS A VERTICAL VACUUM CLEANER

• Press and hold the ON/OFF button (10) to turn the vacuum cleaner on.
• Using the mode switch button (12), select the operating mode of the vacuum cleaner: ECO, STRONG, MAX. The relevant indicator will light up when the mode is selected.

OPERATION/CHERGE INDICATORS
The vacuum cleaner is equipped with LED indicator lights. The following indicators will light up during operation to show the battery status:

• 100 % – battery fully charged
• 50 % – 1/2 charge
• 10 % – battery low.
  When the battery charge is low the 10 % light will blink until the battery becomes fully depleted.

FLAT ATTACHMENT / BRUSH FOR HANDHELD VACUUM CLEANER

Please remove the aluminum tube from the attachment and install the flat attachment or brush directly on the housing.

MAINTENANCE

CLEANING THE FLOOR BRUSH

DUST REMOVAL

• We strongly recommend observing the following maintenance rules; they will help retain the suction capacity and quality performance of the CENTEK TM vacuum cleaner. This is also the prerequisite for free guarantee maintenance.
• Do not wash the filter in a washing machine and do not dry it with a hair drier.
• Check the dust collector and filter after each use of the cleaner. Failure to do this may cause a suction capacity reduction and failure of the appliance.

BATTERY REPLACEMENT
For reasons of safety the Lithium-Ion batteries in this cleaner are only replaceable by a service engineer. When the batteries fail to maintain charge, please contact the Customer Service Centre to arrange a replacement.

END OF PRODUCT LIFE BATTRTY REPLACEMENT
If the cleaner is to be disposed off the batteries should be removed. Used batteries should be taken to a recycling station and not disposed whit household waste. To remove the batteries, please contact the Customer Service Centre or proceed according to the following instructions: IMPORTANT: Always fully discharge the batteries before removal and ensure charger is unplugged.

• Run the unit until the batteries are completely empty.
• Release the handheld unit from the main body of the cleaner.
• Press the dust container release button and remove the dust container.
• Remove 6 screws and open the unit.
• Remove the motor /battery housing and disconnect the cables.
• Remove the batteries from the housing.
  NOTE: Should you experience any difficulties in dismantling the unit or for more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service.

TROUBLESHOOTING

SPECIFICATIONS

• Continuous operating time:
  ECO mode – 50 min;
  STRONG mode – 30 min;
  MAX mode – 10 min.

• Dust container capacity: 0.6 l

• Time to full battery charge: 4-5 hours

ATTENTION! The device should only be used with the power supply supplied with the device.

DISPOSAL

Upon expiry of its service life the appliance can be disposed of separately from ordinary domestic waste. You can turn it over to a specialized electric and electronic appliance disposal and recycling centre.

8. CERTIFICATION DATA, GUARANTEE

The service life of this item is 5 years since the date of sale to the end user, provided the item will be used in strict accordance with the present manual and the applicable technical standards. Upon expiry of the service life please contact the nearest authorized service centre for suggestions as to further operation of the appliance. The manufacturing date of the appliance is integrated into the serial number (digits 2 and 3 – year, digits 4 and 5 – month of manufacture). If any questions related to appliance maintenance should arise, or if the appliance has malfunctions, apply to the CENTEK TM Authorized Service Center. The address of the service center can be found on the website https://centek.ru/servis. Service support contacts: Phone: +7 (988) 24-00-178, VK: vk.com/centek_krd. General Service Center: OOO «Larina- Servis», Krasnodar, Phone: +7 (861) 991-05-42.

The product is provided with the Certificate of Conformity:
№ ЕАЭС RU С-CN.ВЕ02.В.05018/23 of 10.08.2023.

MANUFACTURER AND IMPORTER INFORMATION

Address: Russia, 350912, Krasnodar, ul . Atamana Lysenko, 23, pgt. Pashkovskiy. Phone: +7 (861) 2-600-900.

DEAR VALUED CONSUMER!
The guarantee period for al l appl iances amounts to 12 months since the date of sal e to the end consumer. With this Warranty Card the Manufacturer confirms the proper condition of the appl iance and undertakes to repair, free of charge, all defects caused by the Manufacturer’s default.

GUARANTEE MAINTENANCE TERMS

1. The guarantee shall be valid if the following documentation conditions are observed:
   The original Warranty Card shal l be filled out correctly and clearly, indicating the of appl iance model, serial number and saldate, the stamp of the sel l er company and signature of its representative shall be availed abl e, as wel l as the stamps on each coupon and the buyer’s signature in the Warranty Card.
   The Manufacturer reserves the right to reject guarantee maintenance if the buyer fail s to provide the abovementioned documents or if the information contained therein is incomplete, illegible or ambiguous.

2. The guarantee shall be valid if the following operation conditions are observed:

   • the appliance is used in strict accordance with the present manual;
   • the safety rules and requirements are observed.

3. The guarantee does not apply to regular maintenance, cleaning, installation and setup of the appliance at the owner’s location.

4. The guarantee does not apply in the following cases:

   • mechanical damage;

   • normal wear of the appliance;

   • non-observance of operation requirements or erroneous actions on the part of the user;

   • improper installation or transportation;

   • natural disasters (lightning, fire, flood, etc.), as well as any other causes beyond the Manufacturer’s or Seller’s control;

   • ingress of foreign objects, liquids or insects into the inside of the appliance;

   • repairs or modifications to the appliance by unauthorized persons;

   • use of the appliance for commercial purposes (loads exceeding normal domestic application), connection of the appliance to utility and telecommunication networks incompliant with national technical standards;

   • failure of the following accessories, if replacement of these is allowed by design and does not involve disassembly of the appliance:

   • a) remote control units, rechargeable batteries, replaceable batteries (power cells), external power supply units and chargers;

   • b) consumables and accessories (packaging, covers, slings, carry bags, mesh screens, blades, flasks, plates, supports, grilles, spits, hoses, tubes, brushes, nozzles, dust collectors, filters, smell absorbers);
     – for battery-powered appliances – operation with inappropriate or depleted batteries;

   • – for rechargeable battery-powered appliances – any damage caused by improper battery charging and recharging.

5. The present guarantee is provided by the Manufacturer in addition to the consumer rights determined by the applicable legislation and does not limit these rights in any way.

6. The Manufacturer shall not be made liable for possible damage, directly or indirectly inflicted by CENTEK brand products on people, domestic animals, the consumer’s or third persons’ property if such damage is inflicted as the result of non-observance of appliance installation and operation requirements, deliberate or negligent actions (omission) by the consumer or third persons, as well as of force majeure circumstances.

7. Service centers will only accept appliances in a clean state (there should be no food residues, dust and other contamination on the appliance).
   The Manufacturer reserves the right to change the design and specifications of the appliance without prior notice.

References

• VK.com | VK
• Сервис - Официальный сайт Centek

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>