VEVOR 874128180 Pet Grooming Tub Instruction Manual
- June 10, 2024
- VEVOR
Table of Contents
Installation instructions for pet bathtub
Parts list
1 bathtub cabinet
2 bathtub tailgate
3 the boom
4 bathtub left and right baffles
6 Electric lifting base
7 Door plank of 7
8 the pedal
9 M8 hexagon nuts
10 M8 head screw
11 the faucet| 12 connector
13 flower is aspersed
14 shower hose
15 soap box
16 inlet hose
17 water leakage
18 cushions
19 rubber washer
20 plastic retaining ring
21 outlet
---|---
Assembly instructions
- As shown in the figure, place the bathtub cabinet body on the lifting chassis correctly, and lock the cabinet body with the chassis with bolts (as shown in the figure).
- Put the sponge cushion into the hole at the bottom of the bathtub with the water leakage, and put the rubber washer (threaded side down) from the bottom of the bathtub box Plug in the water leakage and tighten it with the plastic fixing ring. Finally connect the outlet hose and tighten the screws on the hose to prevent it from falling off
- Place the left and right baffles and the back baffle sponge MATS on the upper part of the box body and fix them with bolts
- Place the horizontal bar on the assembled left and right side plates to align with the hole position and tighten it with bolts
Place the pedals into the tub cabinet.
Bolt the soap box onto the two long waist holes on the right panel and adjust
the position to lock the bolt.
Pass the tap inlet through two large round holes in the side plate and screw
the adapter on the other side of the side plate.
Connect the two ends of the hose respectively on the faucet outlet, the
sprinkler inlet, and tighten the sprinkler card into the sprinkler rack.
Connect the two inlet pipes to the other side of the adapter and tighten by
the screwdriver wrench for preventing water leakage.
Pay
special attention to Avoid acids, bases and salts These are corrosive things
Contact box.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>