Alphacool Core 11x 3-Pin DRGB splitter with SATA power connector User Manual
- June 10, 2024
- ALPHACOOL
Table of Contents
Alphacool
Core 11x 3-Pin DRGB splitter with SATA power connector
Read the safety instructions before starting the installation.
Safety instruction
Accessories
|
---|---
1x
aRGB Mainboard Cable
|
1x
Velcro fastener
Note
Switch off the computer. The power switch does NOT turn off the power supply to the computer. To cut off the power supply to the computer, you must unplug the power cord from the wall socket. Make sure the power cord is unplugged before opening the computer chassis.
Mounting
Mount the distributor
- Remove the upper protective film of the adhesive tape and stick it under the Controller.
- Now remove the second protective film of the adhesive tape and stick the Controller to the computer case as shown. The Controller can be detached again through the Velcro layer.
Connect the cable
- Connect the 2 pin aRGB cable to your motherboard aRGB output, ensure the aRBG output is a 3 pin terminal, and not 4 pin, as damage can result of improper connection.
- Connect the 2 pin aRGB IN plug to the controller.
- Connect the SATA power plug from your power supply to the SATA power input of the controller. Ensure power is OFF during this process.
- Connect the other aRGB strips to the sockets (OUT).
- A maximum of 11 aRGB strips with a total power consumption of 22.5W (4.5A) can be connected to the controller.
ALPHACOOL INTERNATIONAL GMBH
MARIENBERGER STR. 1
D-38122 BRAUNSCHWEIG
GERMANY
SUPPORT: +49 (0) 531 28874 – 0
FAX: +49 (0) 531 28874 – 22
E-MAIL: INFO@ALPHACOOL.COM
HTTPS://WWW.ALPHACOOL.COM
GENERAL MANAGERS: ANDREAS RUDNICKI, FABIAN NOELTE
WEEE-REG.-NR.: DE 54464644
TRADE REGISTER: AMTSGERICHT BRAUNSCHWEIG HRB 202390
VAT.ID.NR.: DE270458421
TAX NUMBER: 13/207/02047
V.1.00-05.2022
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>