FLINQ FQC8261 5W Solar LED Floodlight Instruction Manual

FLINQ FQC8261 5W Solar LED Floodlight

Thanks for purchasing one of our items! To ensure continuous operation and accuracy, please read these operating instructions carefully before use and save this manual for future use. Passing certain procedures may result in incorrect reading and incorrect use of this product. We hope that you will enjoy using your new FlinQ-product! If by any chance the item is damaged, defective or broken, you are covered with warranty! Please do not hesitate to contact us for any questions, concerns or suggestions at the email address as mentioned in this manual.

Register your FlinQ product
We can imagine you want to treat your FlinQ item carefully.

Register your product and you will be entitled to the following:

• 1 year extra warranty (2+1)
• Personal support
• Digital warranty certifi cate
• Digital manual

Scan the QR code or go to flinqproducts.nl/registration

Specifications

card)

Working Modes

• Press the on/off button and the lamp will automatically turn on to Sensor Mode.
• Keep pressing the on/off button for 3 seconds and the light will shine one time. Then the lamp turns to constant lighting mode.

Sensor mode

1. Battery above 30% : The lamp will automatically turn on to full brightness when motion is detected in the range ≤6mtrs. After that it will dim to weak brightness in 20 seconds of no motion.
2. Battery below 30%: The lamp will automatically turn on to full brightness when motion is detected in the range ≤6mtrs. After that it will turn off after 20 seconds of no motion.

Constant lighting mode

Constant lighting mode

Press the button for 3 seconds and shining one time, lamp turns to constant lighting mode, both motion and light sensors disabled. Permanently keep lighting until the battery capacity reduces to zero switching back to Sensor Mode.

Applications

• It can be used as wall light, fl ood light, security light, camping light, portable light, work light, hanging light etc, very fl exible and functional!
• You can easily install it in your garden, courtyard, garage, pathway, entrance, villa etc.

Notices

1. This is a solar powered lamp, please install it in a location where can get enough sunshine.
2.  Please note the lighting time depends on sunshine duration & weather & work mode.
3. The lamp will light up automatically at dusk in Sensor Mode.
4. Built-in intelligent IC is with over-charge, over-discharge and over-voltage protection.
5.  The lamp is equipped with an internal battery pack, which is replaceable.If any need, please contact seller for correct new battery pack.
6.  If the battery is taken out and put back in or replaced with new ones, please toward the solar panel to sunshine or a strong light to activate the lamp.
7.  Non-professionals please do not disassemble the lamp.
8.  Please do not dispo se the battery with household garbage to avoid explosion.

Installation

Adjust light and bracket angle

1. Prepare the lamp: Prepare the lamp, accessories and tools well firstly.
2. Adjust light angle: Use Allen wrench to loosen the light panel and adjust it to the demanded lighting angle, then fix the screw tightly.
3. Adjust bracket angle: Rotating the screw to loosen the bracket, adjust it to the appropriate angle.
4. Fix the screw: After adjusting the angle fix the screw tightly.

Put on flat surface

1. Drill the holes: Please use the measure card to drill 2 holes of Φ8mm with a spacing of 132.5mm.
2. Place the lamp on wall: Fix the lamp onto the wall with expansion plugs and screws.
3. Push aside the bracket: Push aside the stand bracket.
4. Place on a flat surface: Place the lamp on a flat surface.

Note: The recommended mounting height is 2-4 meters.

Hang the lamp on the wall

1. Drill holes: Please drill 2 holes of Φ8mm on the wall with a spacing of 88.5mm.
2. Put plugs and screws in holes: Fix the expansion plugs and screws into the holes with a spare space (do not lock to the bottom).
3. Place lamp on the wall: Push aside the stand bracket, align the hanging holes to the screws and hang the lamp on the wall.

Note: The recommended hanging height is < 2 meters.

References

• FlinQ Products | Gratis verzending | 2 jaar garantie | Betaal later

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>