Mercury Netcomm NF15AC WiFi Router User Manual
- June 9, 2024
- Mercury
Table of Contents
Mercury Netcomm NF15AC WiFi Router User Manual
Netcomm NF15ACV Fibre Configuration
Using your own router? No worries, we’ve got you covered!
Log into the gateway:
- Ensure your device is connected to the Router (preferably via cable)
- Open a web browser
- Type the following in the address bar at the top: 192.168.20.1
- Default Username: admin
- Default Password: password
This should then give access to the router’s user interface
(If the password is incorrect you will need to Factory Reset the router by pushing the Inset Reset button on the back for 10 seconds)
How to add correct settings for the Mercury network:
- From the menu on the left select: WAN
- From the sub-menu select: Ethernet WAN
Ensure the following settings are changed:
- Enable VLAN: Ticked
- Channel Mode: PPPoE
- Enable NAPT: Ticked
- Enable QoS: Ticked
- Admin Status: Enable
- MTU: 1492
- Connection Type: Internet
- IP Protocol: IPv4
- PPP Username: (your mercury acct number)@mercurybroadband.co.nz
- PPP Password: password
- Type: Continuous
- Authentication Method: Auto
- AC-Name: (Left Blank)
- Service Name: (Left Blank)
- Select: Apply Changes
You should now be connected to Fibre!
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>