Mercury Netgear D7000 Fibre Modem Router User Guide
- June 9, 2024
- Mercury
Table of Contents
Mercury Netgear D7000 Fibre Modem Router User Guide
Log into the gateway
- Ensure your device is connected to the Router (preferably via cable)
- Open a web browser
- Type the following in the address bar at the top: www.routerlogin.net
- Default Username: admin
- Default Password: password
- Login / Reset Instructions
This should then give access to the router’s user interface
(If the password is incorrect you will need to Factory Reset the router by pushing the Inset Reset button on the back for 10 seconds)
How to add correct settings for the Mercury network
- From the Basic menu select: Internet
- Select Country: New Zealand
- Internet Service Provider: Other
- VLAN ID: Ticked – 10
- Does your internet require a login: Yes
- Encapsulation: PPPoE
- Login: (your mercury acct number)@mercurybroadband.co.nz
- Password: password
- Connection Mode: Always On
- Click: Apply (top of page)
- Select Advanced Menu (from top of page)
- Select: Setup
- Select: WAN Setup
- WAN Preference: Must Use Ethernet WAN
- Click Apply
The router should now reboot. When it comes back online you should now be connected to Fibre!
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>