iottie Velox Pro Magnetic Wireless Charging Dash and Windshield Mount User Guide
- June 9, 2024
- iOttie
Table of Contents
iottie Velox Pro Magnetic Wireless Charging Dash and Windshield Mount User
Guide
Product Assembly
Connect the USB-C cable to your vehicle’s USB-C port or auxiliary power outlet
via an 18W adapter.
Peel off the protective film and tap your MagSafe iPhone against the mount
face. The cooling system will turn on automatically.
Product Installations
A. Dashboard
Choose a flat mounting location on your vehicle’s dashboard and wipe the surface clean. Peel off the film on the dashboard pad and evenly press onto the desired installation location for 30 seconds.
Wait 20 minutes, then remove the plastic cover from the suction cup and firmly
press onto dashboard pad. Push the lever down to engage suction.
If your vehicle has a leather dashboard, we recommend mounting on the windshield to avoid damaging your dash.
B. Windshield
Choose a mounting location on your vehicle’s windshield and wipe the surface clean. Do not use the dashboard pad when mounting on the windshield.
Remove the plastic cover from the suction cup and firmly press onto the
windshield. Push the lever down to engage suction.
MAGSAFE COMPATIBLE
Only compatible with MagSafe iPhone series and MagSafe phone cases.
Declaration of Conformity (FCC)
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. You can refer to the following completed FCC warnings. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference
- This device must accept any interference received, including interference that may cause undesired operation.
Note
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning Statement
RSS-GEN ISSUE 5, 8.4 User manual notice
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B).
-French Warning Statement:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>