Westinghouse PWSG 3200 PSI 50 Foot Extension Hose for Pressure Washers Installation Guide
- June 9, 2024
- Westinghouse
Table of Contents
Westinghouse PWSG 3200 PSI 50 Foot Extension Hose for Pressure Washers
PWSG 3200 PSI 50-FOOT EXTENSION HOSE
FOR WESTINGHOUSE PRESSURE WASHERS
WARNING
User must read and understand the operator’s manual for their pressure washer
before using this accessory to reduce the risk of injury. Fits most pressure
washers. Before using this attachment, make sure it is compatible and is
correctly installed. Risk of fluid injections. Do not point at people, pets,
electrical devices, or the unit itself. Wear eye protection designated to
conform with ANSI Z87.1. Before adding, replacing, or modifying accessories,
turn off the pressure washer, release the water pressure in the trigger
handle, and lock the trigger handle’s lock out (if one is provided with your
pressure washer). Use only with cold water and only outdoors. Store the
accessory indoors.
INSTALLING THE HIGH PRESSURE HOSE
See Figure 1.
- A – High pressure hose (manguera de alta presión, tuyau haute pression)
- B – Collar (collar, collier)-
- Thread the collar of the high pressure hose clockwise onto the trigger handle’s coupler. Be careful not to cross-thread.
- Pull on the hose to be certain it is secure.
WARNING
Hold the trigger handle securely with both hands when the unit is on to reduce
the risk of injury from kickback.
Service Hotline: 855-944-3571
777 Manor Park Drive, Columbus, OH 43228 and Westinghouse are trademarks of
Westinghouse Electric Corporation.
Used under license by MWE Investments, LLC.
© 2022 MWE Investments, LLC All Rights Reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>