Westinghouse PWSG 3600 PSI Short Trigger Handle for Pressure Washers Installation Guide
- June 9, 2024
- Westinghouse
Table of Contents
Westinghouse PWSG 3600 PSI Short Trigger Handle for Pressure Washers
PWSG 3600 PSI SHORT TRIGGER HANDLE
FOR WESTINGHOUSE PRESSURE WASHERS
WARNING
User must read and understand the operator’s manual for their pressure washer
before using this accessory to reduce the risk of injury. Fits most pressure
washers. Before using this attachment, make sure it is compatible and is
correctly installed. Risk of fluid injections. Do not point at people, pets,
electrical devices, or the unit itself. Wear eye protection designated to
conform with ANSI Z87.1. Before adding, replacing, or modifying accessories,
turn off the pressure washer, release the water pressure in the trigger
handle, and lock the trigger handle’s lock out (if one is provided with your
pressure washer). Use only with cold water and only outdoors. Store the
accessory indoors.
INSTALLING THE TRIGGER HANDLE
See Figure 1.
- Thread the collar of the high pressure hose clockwise onto the trigger handle’s coupler.
- Pull on the hose to be certain it is secure. Be careful not to cross-thread.
FIG. 1
- A – High pressure hose
- B – Collar
USING THE TRIGGER HANDLE
See Figure 2.
Always hold the trigger handle with both hands for greater control and safety.
- Pull back on the trigger to begin operation.
- To stop the flow of water, release the trigger. To lock the trigger:
- Move the lockout into the slot on the handle. To unlock the trigger:
- Move the lockout into the slot on the handle.
FIG. 2
- A – Lock out
- B – Slot
- C – Trigger
Service Hotline: 855-944-3571
777 Manor Park Drive, Columbus, OH 43228
and Westinghouse are trademarks of Westinghouse Electric Corporation. Used
under license by MWE Investments, LLC.
© 2022 MWE Investments, LLC All Rights Reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>