FLINQ Solar Lamp Geisha User Manual
- June 9, 2024
- FlinQ
Table of Contents
FLINQ Solar Lamp Geisha
SPECIFICATION
- Product Name: FlinQ Solar Lamp Geisha
- Power/Lumen: 1.5W Plus/220lm
- LED: SMD2835*14 PCS (Front 12 PCS + Back 2 PCS)
- Beam Angle: 90ºc
- Li-ion Battery: 1200 mAh/3.7V (replaceable)
- Solar Panel: 0.7 Wp, mono-crystalline silicon
- Detection angle/area: 120ºc /<6 meters
- IP Degree: IP65 Waterproof
- Warranty: 24 months (battery 12 months warranty)
- Lifespan: 35.000 hours
- Installation height: <4 meters
- Packing: Blister Package (1x Solar Light, 1x Color Page, 1x Accessory bag, 1x User manual, 1x Measure card)
Installation
- Hole
- Expansion Plug
- Screw
- Mounting Hole
- Button
- Please use the card to measure hole position correctly and drill 2 holes of 6mm
- Fix 2 expansion plugs into the holes
- Fix a screw to the lower expansion plug with a spare space. Insert the notch onto the screw.
- Straighten the whole lamp and fasten the upper screw.
- Press the button to adjust to demanded working mode.
Notice
- This is a solar-powered lamp, please install it in a location where there is enough sunlight.
- The lamp will automatically light up when it is dark.
- Please note the lighting time depends on sunshine duration and weather.
- Built-in intelligent IC equipped with over-charge, over-discharge and over-voltage protection.
Warning
- The lamp is equipped with an internal lithium battery, which is replaceable. If and needed, please contact the seller for new battery.
- If the battery is taken out and put back in or replaced by a new one, please put the solar panel towards the sun again to activate the lamp.
- Non-professionals please do not disassemble the lamp.
- Please do not exposure the battery with household garbage to avoid explosion.
Working Modes
Please press the button to select the working mode:
- Press first time for Mode A.
- Press second time for Mode B
- Press third time to turn OFF.
Mode A
Automatically turns on to full brightness (220lm) when motion is detected in the range <6meters and then turns to weak brightness (front light on & back light on) in 10 seconds of no motion.
Mode B
Automatically turns on to full brightness (220lm) when motion is detected in the range <6meters and then turns to weak brightness (front light off & back light on) in 10 seconds of no motion.
FlinQ Commerce
- Eemweg 74, 3755 LD Eemnes www.flinqproducts.nl
- For support and warranty information: info@flinqproducts.nl
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>