Intelligent IFSGA003AC-ANON Dryflow Tri-Tap Water Sensor Tap Instruction Manual
- June 9, 2024
- Intelligent
Table of Contents
Intelligent IFSGA003AC-ANON Dryflow Tri-Tap Water Sensor Tap
The trusted independent experts for hand dryers and washrooms since 2012.
INSTALLATION INSTRUCTIONS
We strongly recommend that you use a qualified and registered plumber and electrician.
Note: Always flush pipework before installation.
- Push flexi hose and control cable through the hole in the wall or S/S wall mounting plate and tighten the nut.
- Insert batteries into the control box. (See drawing)
- Screw the control box to wall (Within the length of the flexible pipe and control cable) (control box can be located in a wall cavity with access if required)
- Connect flexi hose from tap to outlet of the control box, squeeze clamp over hose and slide pipe onto the outlet of control box then release clamp to secure.
- Connect the water feed to the inlet of the control box.
- Connect the transformer to the control box.
TECHNICAL SPECIFICATION
COMPONENTS
TROUBLESHOOTING
No water out
| The batter is exhausted Water supply cut off Dirt in the filter
Water pressure to low
| Change the battery Check Supply Clean the filter Raise the pressure
---|---|---
Water will not turn off| Dirt on the sensor window| Clean the sensor
Too little water flow
| Water supply is turned down The filter is too dirty
Water pressure is too low
| Adjust water supply Clean the filter Raise the pressure
Too much water flow| Water pressure is too high| Adjust pressure
Short cycles of battery| lncorrect batteries| Change to 4AA Alkaline batteries
The indicator light is not on| The light is broken
The circuit board is wet or signal line is wet
The battery is exhausted Poor connection of battery
| Change the light or circuit board
Dry out
Change the battery
Check battery connections
Flashing sensor light| Battery running low| Replace battery
lnlet filter cleaning| Control box has a filter on the inlet| Remove filter
and wash out
any obstructions
AFTERCARE
Whilst advanced plating techniques are used in the manufacture of this
product, the surface will be affected if cleaned incorrectly. Surfaces should
be maintained using a clean damp cloth, no abrasive agents or materials should
be used or come into contact with the surface finish, or this will invalidate
your guarantee.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>