Guardian MDS86012CHR Wall Grab Bar Instruction Manual

Guardian MDS86012CHR Wall Grab Bar Instruction Manual

WARNING

Failure to properly install grab bar may result in severe injury. Read these warnings carefully before using the product.

• Special fasteners may be required if wood stud is not in desired If you have any questions or concerns, we suggest installation by a qualified tradesman.
• Keep screws All screws should be checked for tightness before use.
• Test unit before Before using the grab bar, test for stability by vigorously attempting to move the bar.

INSTALLATION INSTRUCTIONS*

Tools Required for Grab Bar Installation:

3/8″ (0.95 cm) or 1/4″ (0.63 cm) electric drill, extension cord, 5/32″ (0.40 cm) drill bit for drilling pilot hole in wood stud, 1/4″ (0.63 cm) drill bit for clearance hole with tile if

appropriate, sharp center punch,level, soft grease pencil, hammer, screwdriver, stud finder, toggle bolts (if not able to install into wall stud).

Included: Included: 6- 2″ (5.08 cm) screws and 2 rubber gaskets

(Gaskets Contain Dry Natural Rubber.)

1. Position grab bar at angle which best accommodates user’s needs and also allows at least one end to be mounted into the wall Mark hole locations with soft grease pencil. When locating vertical or horizontal positions, use your level. If one end cannot be mounted into a wall stud, you must use a butterfly toggle fastener (not supplied).
2. MOUNTING DIRECTLY INTO WOOD STUDS:
   • Drill 5/32″ (0.40 cm) pilot Place rubber gasket between bar and the wall. Insert the screws through hole in bar and hole in the rubber gasket.

MOUNTING THROUGH TILE: (Caution: Avoid drilling into water lines)

• At the mark for your hole, take your sharp center punch and gently chip the glaze The chipped area need be no larger than the hole you are going to drill.
• Once the glaze is chipped, take the 1/4″ (0.63 cm) tile drill bit and drill into the If you strike wood, stop drilling. Switch to the 5/32″ (0.40 cm) drill bit and drill 1″ (2.54 cm) into the wood. First insert the screw through the screw cover base. If you do not penetrate wood, see instructions for mounting with a toggle bolt.

MOUNTING USING A TOGGLE FASTENER (not supplied)

• Drill hole using drill bit large enough to receive the toggle fastener.
• Insert the toggle bolt through the hole for the screw cover base, spin butterfly tip on just enough to be secure, then feed bolt through large hole
• Once the butterfly is inserted it will fly open on the inside of the Pull out on the grab bar to make sure the butterfly has opened properly (reference illustration). Drive screw down until you feel the bar snug to the wall using screwdriver.

1. Test bar for tightness by applying full body force to the bar to make sure that it is solidly

*Manufacturer bears no responsibility for improper installation.

USER INSTRUCTIONS

Firmly grasp bar. Pull up firmly on the bar to move into a safe, comfortable position in the bathtub or toilet area. Afterward grasp the bar firmly to transfer back into your original position.
NOTE: THIS PRODUCT CONTAINS DRY NATURAL RUBBER.
DO NOT EXCEED USER WEIGHT CAPACITY OF 250 LBS (113 KGS).

Read More About This Manual & Download PDF:

References

• Home | Medline Canada

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>