VIDEX VLE-FSO3-205 LED Solar Flood Light User Manual

: June 9, 2024
: VIDEX

Table of Contents

VIDEX VLE-FSO3-205 LED Solar Flood Light
TECHNICAL
INTERPRETATION OF ICONS
ENVIRONMENTAL PROTECTION
- OPERATING INSTRUCTIONS
FUNCTIONAL CHARACTERISTICS
MAINTENANCE AND SAFETY INSTRUCTIONS
WARRANTY
Documents / Resources

VIDEX VLE-FSO3-205 LED Solar Flood Light

VIDEX-VLE-FSO3-205-LED-Solar-Flood-Light-PRODUCT

TECHNICAL

INDEX	VLE-FSO3-205
1. Flood light	1.1.Luminous flux
1.2. Color temperature	5000 K
1.3. LED type	SMD 5050

1.4. Color Rendering

Index

voltage

| 1000V
3.8. STC| 1000W/M2, AM1.5;

25°С

4. Remote controller| Infrared, CR2032 powered
5. Cable length| 1.5m
6. Full charge| 5-8 h (sunny weather)
7. Full discharge| ≤ 12 h

INTERPRETATION OF ICONS

Dimmable by remote controller
Color rendering index
Color temperature
Ultra-violet free
Mercury free
Nominal beam angle
Nominal lifetime
On/off cycles
No perceptible fl icker to the human eye
Mechanical impacts protection
Operating temperatures range
Protection against dust and water
Working time at full charge
Minimum distance from the illuminated object
The product can be installed and used on/in normally fl ammable surfaces
Immediately replace the lamp broken cover
The product contains non-replaceable light source
For outdoor use only
Recommended mounting height
The product meets requirements of EU directives
The product complies with the technical regulations of Ukraine.

ENVIRONMENTAL PROTECTION

29. Pursuant to the provisions of the WEEE Act, it is forbidden to put waste equipment marked with the symbol of a crossed bin together with other waste. The user, wishing to get rid of electronic and electrical equipment, is obliged to return it to a waste equipment collection point.
There are no hazardous components in the equipment that have a particularly negative impact on the environment and human health.

PRODUCT’S PURPOSE AND APPLICATION

This product is intended for the autonomous illumination of open spaces, parks, and private home areas.

INSTALLATION INSTRUCTIONS

Read the user’s manual before installation and use. The flood light and the solar panel are integral parts. Separate parts cannot be used independently.
a) Fasten the bracket to the solar panel (Fig.2);
b) Drill the holes in the mounting surface and install the flood light and the solar panel using dowels and screws (not included) (Fig.3);
c) Adjust the tilt angle of the lamp and the solar panel then tighten the appropriate screws to fix them (Fig.4);
It is recommended to install the solar panel perpendicular to the sun’s rays in order to expose maximum performance (Fig.1).
d) Connect the solar panel to the flood light and tighten the nut (Fig.5).

OPERATING INSTRUCTIONS

The lamp will automatically turn on at night and turn off during the day.
The solar panel converts sunlight into electricity and charges the fl oodlight battery.
Note: Before normal use, make sure that the fl ood light is fully charged for up to 8 hours under direct sunlight.

REMOTE CONTROLLER INTRODUCTION (Fig.6):

Turn ON: Click one time for turning on. When the lamp is in the charging state, it will automatically turn off after 2 minutes.
Turn OFF: Click one time for turning off . When the lamp is in the discharge state, it will automatically turn on after 2 minutes; double-click enter sleeping mode, under this mode the lamp won’t work.
Full brightness: 100% brightness working until the battery runs out.
Half-brightness: 50% brightness working until the battery runs out.
Increase the brightness by 5%
Reduce the brightness by 5%
Check the battery level: click to see the battery level that will last for 3 seconds. The battery status is also continuously displayed when the fl good light is charging.
Auto mode: Click the «AUTO» button at any time to cancel all settings and switch to automatic charging and discharging mode; light on for 3 hours at 100% power, 3 hours at 70% power, and run at 30% power until the battery runs out.
Wake up: fi nish installing the lamp, you need to click the «WAKE UP» button to wake up the lamp for the fi rst time using, and it can be automatically charged and discharged.
Auto shutdown timer in 3 hours: timed for 3 hours, automatically shut down after 3 hours of discharge. With memory function, it will shut down after 3 hours of discharge every day.
Auto shutdown timer in 5 hours: timed for 5 hours, automatically shut
down after 5 hours of discharge. With memory function, it will shut down after 5 hours of discharge every day.
Auto shutdown timer in 8 hours: timed for 8 hours, automatically shut down after 8 hours of discharge. With memory function, it will shut down after 8 hours of discharge every day.

Remark:

The sleep mode has been set by factory as default in order to prevent accidental activation during transportation. Press the «WAKE UP» button to activate it before use.
If the product needs to be stored for a long time, please switch to sleep mode. («double-click» the OFF key)
Flashing red light stands for normal charging, and the green light on stands for full power.

FUNCTIONAL CHARACTERISTICS

This product should be used outdoor only.

MAINTENANCE AND SAFETY INSTRUCTIONS

For the long periods of storage, it is recommended to keep the battery charging level at about half capacity to extend its service life. Do not store with discharged battery.
Clean only with soft and dry cloths. Do not use chemical detergents
ATTENTION! Do not look directly at LED light beam.
It’s forbidden to use the product with damaged cover.
Do not disassemble the sealed body of the lamp as this may compromise performance and void the warranty.
Product must not be used in unfavorable conditions, e.g. vibrations, explosive air atmosphere, fumes, or chemical fumes, etc.
The LED light source and the battery inside the product are not replaceable.
If the LED light source or the battery fails, the whole product should be disposed of in accordance with applicable regulations.

WARRANTY

The warranty for the product is 2 years. During the warranty period, a faulty product can exchanged or returned with prove of purchase and all accessories saved. The following does not apply with the scope of limited warranty:
Misuse the product and cause the products components damage;
Unauthorized disassemble or the presence of deep mechanical damage to the product;
Damage due to force majeure.
The producer shall not be responsible for any damage resulting from the failure to follow above instructions.
The producer reserves the right to make updates of this user’s manual.
www.videx.ua
Made in P.R.C. Store unused for no more than 2 years.
www.videx.com.pl

Documents / Resources

| VIDEX VLE-FSO3-205 LED Solar Flood Light [pdf] User Manual
VLE-FSO3-205 LED Solar Flood Light, VLE-FSO3-205, LED Solar Flood Light, Solar Flood Light, Flood Light, Light
---|---