LiGHTPRO 215A 12V Tube User Manual
- June 9, 2024
- LiGHTPRO
Table of Contents
LiGHTPRO 215A 12V Tube
User manual
Thank you for purchasing the Lightpro Tube. This document contains the required information for correct, efficient and safe use of the product. Consult the general manual of the Lightpro 12-volt system and the user manual of your transformer for more information about the set up and connection of your light plan. Read the information in this manual carefully before using the product. Keep this manual near the product for consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Tube can be used in combination with the Lightpro Juno Tube. It can be placed in the ground using the supplied ground spike, but can also be used for wall mounting. This product may only be used as outdoor lighting in combination with the Lightpro 12-volt system. Any alterations made to the product may have consequences for the safety, guarantee and correct functioning of the product and/or other parts of the system.
SPECIFICATIONS
- Product: Tube
- Article number: 215A
- Dimensions (h x Ø): 1200 x 20 mm
PACKAGING CONTENT
- Tube
- Screws
- Dowel
- Allen keys
- Spacer
- Mounting blocks
- Cover caps
- nsert
- Plug
- Plug attachment
- Cover caps of the tube
Check if all parts are present in the packaging. For questions about parts, service, and any complaints or other remarks, you can always contact us. E-mail: info@lightpro.nl
The system
INSTALLATION
- Secure the tubes to each other with the insert and tighten the screws with the Allen key.
- Place the cover cap on the tube.
OPTION 1: INSTALLATION ON THE GROUND. [Figure B]
- Place the plug attachment on the pipe and tighten the screws with the Allen key.
- Mount the connector on the connector attachment.
OPTION 2: WALL-MOUNTED INSTALLATION. [Figure C]
Place the two mounting blocks in the desired location.
- Screw the screw into the wall at the desired location.
- Place the spacer over the screw.
- Screw the mounting block onto the screw.
[Figure D]
- Slide the pipe through one of the mounting blocks. Then slide the mounting blocks for the spotlight(s) onto the pipe.
- Slide the tube through to the 2nd mounting block on the wall. Make sure that the cable guide is at the back and then screw it onto the front of the mounting block.
- Place the cover cap at the back.
MOUNTING SPOT
[Figure D]
- Place the friction ring [1] on the mounting block [6].
- Turn the spotlight with the cables as a package on the mounting block until you begin to feel resistance and slide the lamp to the desired position.
- Slide the mounting blocks for the spotlight(s) to the desired position.
- Secure them at the back with the set screw and place the cover cap [7].
[Figure E]
Route the cable by pushing it into the recess at the back of the tube.
Carefully slide the mounting blocks over the tube when the cable is in the tube to avoid damaging the cable. Repeat this step in case more spots are mounted.
UK Authorised Representative (for authorities only) ProductIP (UK) Ltd. 8, Northumberland Av. London WC2N 5BY
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>