POTTER NGP-1000D-M3 Nitrogen Generator with 1,000 Gallon Largest Riser Owner’s Manual
- June 9, 2024
- POTTER
Table of Contents
POTTER NGP-1000D-M3 Nitrogen Generator with 1,000 Gallon Largest Riser
Features
- Complete skid mounted unit – easy plug and play installation
- Integrated 2 HP oil-less air compressor needed for NFPA 13 required 30 minutes fill for 1000 gallon system at 40 PSI
- Handles up to 5000 gallons of total sprinkler system capacity (based on NFPA 13 allowable leak rates for a new sprinkler system)
- Premium nitrogen membrane
- UL 508A listed industrial control panel
- Requires only one power connection
- Built-in Programmable Logic Controller for leak detection and air bypass alarm systems
- Form C dry contacts for Building Management System (BMS) notification
- 30 gallon air tank and 30 gallon nitrogen tank
- Includes all filters, relief valves, automatic drains and gauges
Description
The Potter Nitrogen Generator, NGP-1000D-M3, is specifically designed to
provide on-site, high purity nitrogen for use in fire protection sprinkler
systems. When used as a supervisory gas in fire sprinkler systems, nitrogen
slows corrosion, improves the life of your system, and lowers maintenance
costs. Potter Nitrogen Generators are fully assembled packages ready to be
connected to a new or existing fire sprinkler system. These turn-key systems
include all air filtration equipment, an air compressor, nitrogen membrane, as
well as tanks required to keep the generator operating at peak efficiency.
Potter Nitrogen Generator Systems provide a low cost, reliable, and efficient
method of producing a minimum of 98% nitrogen at the point of usage.
The NGP-1000D-M3 utilizes nitrogen membrane technology for gas separation.
Nitrogen membranes are highly effective and a cost conscious way of producing
on-site nitrogen. Acting as a filter, the smaller oxygen and water vapor
molecules can pass through the membrane quickly. The larger nitrogen molecules
are less likely to diffuse through the separator tubes; therefore, they
continue downstream to the separator outlet, through the air maintenance
device and into the fire protection system. As the system fills with nitrogen,
the remaining oxygen molecules in the fire protection system are exhausted by
using the Potter IntelliPurge® Nitrogen Purge Valve. The Potter IntelliPurge®
Nitrogen Purge Valve will periodically monitor the fire protection system to
ensure high purity nitrogen is consistent throughout the sprinkler system.
Installation
The Potter NGP-1000D-M3 should be installed in a dry, clean, and well- ventilated room with ambient temperatures above 50°F at all times.
Allow access to the front for service and place the unit in a location that is
conveniently located near fire sprinkler system connections and a drain.
The Potter Nitrogen Generator should always be installed in an adequately
ventilated room. Nitrogen is nontoxic and largely inert. Rapid release of
nitrogen gas into an enclosed space displaces the oxygen and can cause an
asphyxiation hazard. Inhalation of nitrogen in excessive concentrations can
result in unconsciousness without any warning symptoms.
For detailed installation and operation instructions please refer to the
Potter Nitrogen Generator Manual #5401548.
Technical Specifications
| Size (HxWxD) | 62” x 44” x 33” |
|---|---|
| Weight | 550 lbs |
Power Supply
| Available in 208V (11.6A), 230V (11A), single phase and 208V (9.2A), 230V
(9.2A), 460V (4.6A) three phase
Fire Sprinkler System
Connection
| ½” Female NPT
Mounting Holes| (4) ½” Ø
Max operating Pressure| 100 PSI
Temperature Range| 50°F (10°C) to 110°F (43°C)
Air Purity
| ISO Class 1.4.1 or better: Free of water 38°F (3°C) Dew Point, compressor oil (0.008 PPM or .01 mg/m3), hydrocarbons, and particles (<0.01 μm microns)
Dimensions
Ordering Information
Model| Description| Stock No.| | Model|
Description| Stock No.|
---|---|---|---|---|---|---|---
NGP-1000D-M3-2A| SINGLE PHASE 208V| 1119524| NGP-MK| Maintenance Kit M2-M5|
1119785|
NGP-1000D-M3-3A| SINGLE PHASE 230V| 1119526| INS-PV| Potter IntelliPurge®
Nitrogen Purge Valve| 1119478|
NGP 1000D-M3-2B| THREE PHASE 208V| 1119527|
NGP-SPV| Potter Purge Valve| 1119784|
NGP 1000D-M3-3B| THREE PHASE 230V| 1119528|
NGP-AMD-1| Potter Air Maintenance Device| 1119787|
NGP 1000D-M3-4B| THREE PHASE 460V| 1119529|
|
Potter Electric Signal Company, LLC
St. Louis, MO
Phone: 800-325-3936
www.pottersignal.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>