BLAUPUNKT LED Digital FM Clock Radio with Dual Alarm User Manual

BLAUPUNKT LED Digital FM Clock Radio with Dual Alarm User Manual

LED DIGITAL FM CLOCK RADIO WITH DUAL ALARM RADIOBUDZIK Z DWOMA ALARMAMI

• This safety and operating instruction should be retained for future reference.
• The apparatus should not be exposed to dripping or splashing or placed in a humid atmosphere such as a bathroom.
• Do not install the product in the following areas:
• Places exposed to direct sunlight or close to radiators.
• On top of other stereo equipment that radiate too much heat.
• Blocking ventilation or in a dusty area.
• Areas where there is constant vibration.
• Humid or moist places.
• Do not place near candles or other naked flames.
• Operate the product only as instructed in this manual.
• Before turning on the power for the first time, make sure the power adaptor is properly connected.

For safety reasons, do not remove any covers or attempt to gain access to the inside of the product. Refer any servicing to qualified personnel.
Do not attempt to remove any screws, or open the casing of the unit; there are no user serviceable parts inside. Refer all servicing to qualified service personnel.

SAFETY INSTRUCTIONS

1. Read Instructions – All the safety and operating instructions must be read before the product is operated.

2. Retain Instructions – The safety and operating instructions should be kept with the product for future reference.

3. Heed warnings – All warnings on the product and in the operating instructions should be adhered to.

4. Follow instructions – All operating and users’ instructions should be followed.

5. Water and moisture – To reduce the risk of fire or electric shock, do not expose the product to train, dripping, splashing or excessive moisture such as in a sauna or bathroom. Do not use this product near water, for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement or near a swimming pool (or similar).

6. Object and Liquid Entry – Never push objects of any kind into this product through openings, as they may touch dangerous voltage points or short-circuit parts that could
   result in a fire or electric shock. Never spill liquid of any kind on the product. Do not place any object containing liquid on top of the product.

7. Servicing – Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to
   qualified service personnel.

8. Replacement parts – When replacement parts are required, ensure that the service technician has used replacement parts specified by the manufacturer or have the same
   characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards.

9. Place your clock radio on a stable surface, away from sources of direct sunlight or excessive heat or moisture.

10. Protect your furniture when placing your units on a natural wood and lacquered finish by using a cloth or protective material between it and the furniture.

11. Clean your unit with a soft cloth moistened only with mild soap and water. Stronger agents such as benzene, thinner or similar materials can damage the surface of the unit.
    Make sure the unit is unplugged before cleaning.

12. Battery

1. The batteries must not be exposed to excessive heat such as sunshine, fire or the like.
2. The batteries should be drawn to the environmental aspects of battery disposal.
3. Battery usage CAUTION – to prevent battery leakage which may result in body injuries,
   property damage, or damage to the apparatus:
   -Install all batteries correctly, + and – as marked on the apparatus.
   -Remove batteries when the unit is not used for a long time.

WARNING

This appliance is not intended for use by persons (including children) with reduced physical sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

1. The apparatus must not be exposed to dripping or splashing and that objects filled with liquids, such as vases, must not be placed on the apparatus.
2. To prevent fire or shock hazard, do not expose this equipment to hot places, rain, moisture or dust.
3. Do not locate this unit near any water sources e.g. taps, bathtubs, washing machines or swimming pools. Ensure that you place the unit on a dry, stable surface.
4. Do not place this unit close to a strong magnetic field.
5. Do not place the unit on a amplifier or receiver.
6. Do not place this unit in a damp area as the moisture will affect the life of electric components.
7. If the clock is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the player. If this occurs, the system will not operate properly. Please leave the system turned on for about an hour until the moisture evaporates.
8. Do not attempt to clean the unit with chemical solvents as this might damage the finish. Wipe with a clean, dry or slightly damp cloth.

This product complies with the radio interference requirements of the European community.

Your products is designed a manufactured with high quality materials and components, which can be recycled and reused.

When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/EC. Please inform yourself about
the local separate collection system for electrical and electronic products. Please cat according to your local rules and do not dispose of your old products with your normal
household waste. Correct disposal of your old product helps to prevent potentialnegative consequences for the environment and human health.

Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be dispose with normal household waste. Please inform yourself about the local
rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health.

Environmental information

All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box),polystyrene foam(buffer) and poly
ethylene (bags, protective foam sheet). Your system consists of material which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment. Recording and playback of material might require consent. See Copyright Act 1956 and The Performer’s Protection Acts 1958 to 1972.

INSTALLATION

Plug the AC/DC adaptor to an AC household outlet, and then plug the DC jack to the back
of the unit. Your clock radio is ready to work for you.

BACKUP BATTERY INSTALLATION

Your clock radio requires one CR2032 lithium battery (not included) to provide backup power to the clock in the event of a temporary power interruption.

1. Place your unit face down on a flat surface.
2. Slide and remove the battery cover at the bottom of your unit.
3. Insert one new CR2032 lithium battery into the battery compartment with the”+” side facing up as indicated.
4. Replace the battery cover.

-If AC power is interrupted, the LED display will go off and both the radio and the alarm will not function. The backup battery will keep the time and all settings of your unit. Make sure
a fresh CR2032 lithium battery is used. A fresh CR2032 battery could backup your clock continuously for around 3 days.

-SETTING TIME, 12/24HR TIME AND THE SNOOZE DURATION

1. Press SET once, the hour digits flash. Press to set the current hour (hold to advance rapidly).
2. Press SET again, the minute digits flash. to set minutes. (hold to advance rapidly).
3. Press SET again, the display shows “24H” and flashes. Press to select “12H” or “24H” time format.
4. Press SET again, the display shows “OS” and flashes. Press to select your snooze time from 5 to 60 minutes.
5. Press SET again or if no key is pressed in approx. 10 seconds to exit the setting mode.

Note:  when 12-hour time format is selected, the P (PM) LED will appear at the lower middle part of the time display to indicate the afternoon time; there is no AM indicator.

SETTING THE ALARMS

1. Press AL 1.2 once, the A 1 LED and the hour digits flash. Press to set the alarm 1 hour. (hold to advance rapidly).

2. Press AL 1 .2 again to adjust minutes. Press to set the alarm 1 minutes. (hold to advance rapidly).

3. Press AL 1.2 again, LED displays “OFF” (alarm off). To select wake to sound sources, press to select:-
   rd = wake-by-radio
   bu = wake-by-buzzer
   OFF = alarm off

4. Press AL 1.2 again, the A2 LED and the hour digits flash. Press A or T to set the alarm 2 hour. Repeat step 2) and 3) to set alarm 2. Press AL 1.2 again or no button is pressed in around 10 seconds to exit alarm setting mode. When wake-by-radio or wake-by-buzzer is selected, the related alarm is turned on, indicated by appearance of the A 1 and/ or the A2 LED on the
   left side of the display.

Note: Alarm function can only be operated at AC mode only.

STOP AND RESET THE ALARM TO COME ON THE NEXT DAY

When alarm 1 or 2 is sounding, the related A 1 or A2 LED flashes. Press the RADIO/ SLEEP or AL 1.2 once to stop the alarm and reset it to come on the following day. After that,
A 1 or A2 icon stays on the display.

SNOOZE OPERATION (default snooze duration is 5 minutes)

When alarm is sounding, press once, the alarm will be silenced and come on again after the set snooze duration.

Note: If your second alarm activates while the first alarm is sounding or it is in the snooze mode, the second alarm overrides the first alarm (the first alarm is reset to come on the next day).

USING THE HI-LO DIMMER

Press to adjust the brightness (HI/ LO/OFF) of the LED display. This can only be done when the radio is off or the unit is not sounding.

SETTING UP THE FM ANTENNA

Extend the FM wire antenna fully and vary the direction for the best FM reception. Do not strip, alter or attach to other antennas.

LISTENING TO THE FM RADIO

1. To turn on the radio, press RADIO/SLEEP once, the display shows “ON” and then shows the radio frequency readings in Mhz.
2. Press to tune the radio to a desired station. Press and hold  to scan for the next clear station.
3. To adjust the volume, press VOL once, the display shows “L07”, press to adjust volume from L01 (minimum) to L 15 (maximum)
4. Press to turn off the radio.

Remark: Keep your radio away from fluorescent lamps or other electronic devices, which may cause interference to the radio.

USING THE PRESET MEMORY

This clock radio features 10 preset memories of FM stations. These allow you to preset your favorite stations and access them quickly.

1. Turn on the radio and select a radio station you like to memorize.
2. Press and hold the SET until MEM LED appears and “01” flashes. Press SET once to store Memory 1.
3. Press to select another station you like to memorize. Then press and hold SET until MEM LED appears and “01” flashes. Press once, “02” appears. Press SET once to store Memory 02.
4. Repeat Step 2 to 3 to preset memories 3 through 10.
5. To access a preset station at any time, simply press the SET once at a time while the radio is on.
6. To edit a preset station, select another station and then repeat Step 2 to 4. This overrides the original settings.

USING THE SLEEP TIMER

1. Press the RADIO/SLEEP twice to enter the sleep mode. The SL (SLEEP) LED and the sleep time “05” (5 minutes) and will flash on the display.
2. Press the RADIO/SLEEP again as needed to adjust the sleep t imer from 5, 15, 30, 45, 60, 75, 90 or OFF.
3. When the display changes back to show the time, simply press the RADIO/SLEEP twice to show the sleep time remaining.
4. The radio will play for the programmed sleep t ime and then turn off automatically.
5.  To turn off the radio before the sleep time has elapsed, press Zz •~ once.

TROUBLE SHOOTING

If your clock displays irrelevant time or does not function properly, which maybe caused by electro-static discharge or other interference, unplug the DC jack to disconnect the AC
power (and remove the backup battery). The clock radio will be reset to default settings and you need to set it again.

CARE OF YOUR PRODUCT

1. Place your clock radio on a stable surface, away from sources of direct sunlight or excessive heat or moisture.
2. Protect your furniture when placing your units on a natural wood and lacquered finish by using a cloth or protective material between it and the furniture.
3. Clean your unit with a soft cloth moistened only with mild soap and water. Stronger agents such as Benzene, thinner or similar materials can damage the surface of the unit. Make sure the unit is unplugged before cleaning.
4. If the unit is not to be used for a prolonged period, such as a month or longer, remove the batteries to prevent possible corrosion. Should the battery compartment become corroded or dirty, clean the compartment thoroughly and replace the batteries.

SPECIFICATIONS

Alarm duration 1 hour (3-minute on, 9-minute off interval)
Snooze duration S to 60 minutes
Sleep timer selections 5, 15, 30, 45, 60, 75, 90 minutes to OFF
Volume L01 (minimum) to L 15 (maximum)
Preset Memories of radio 1 0

Default settings:-
Time format                                24hour
Time                                            0:00
Alarm 1 and 2                              6:00
Volume                                        L07 (Level 7)
Snooze duration                          05 (5 minutes)

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>