MONACOR 1000875 Travel Tie Clip Microphone Instructions

MONACOR 1000875 Travel Tie Clip Microphone

Tie Clip Microphone

These instructions are intended for users without any specific technical knowledge. Please read these instructions carefully prior to operation and keep them for later reference.

Applications

This tie clip microphone with high-quality electret microphone capsule is ideally suited for speech applications, e. g. audio recordings of interviews. The microphone has its own battery supply; therefore, it can also be used on a microphone input that does not provide any supply voltage. The following accessories are supplied with the microphone: a windshield, a clip, a pouch and an adapter plug (3.5 mm to 6.3 mm).

Important Notes

The product corresponds to all relevant directives of the EU and is therefore marked with . The product corresponds to the relevant UK legislation and is therefore marked with UKCA.

• The product is suitable for indoor use only. Protect it against dripping water, splash water and high air humidity. The admissible ambient temperature range is 0 – 40 °C.
• For cleaning the product only use a dry, soft cloth; never use water or chemicals.
• No guarantee claims for the product and no liability for any resulting personal damage or material damage will be accepted if the product is not correctly used or not expertly repaired.

If the product is to be put out of operation definitively, dispose of the product in accordance with local regulations.

Overview

1. Microphone with windshield

2. Clip to attach the microphone to your clothes

3. Battery capsule

4. Switch POWER for battery supply
   ON: battery supply activated
   OFF: battery supply deactivated

5. 3.5 mm plug (4-pole)

6. Adapter plug 3.5 mm to 6.3 mm (2-pole), e. g. for connection to the microphone input of a mixer

Inserting the Battery

Note: A battery is only required when the microphone is connected to a jack that does not provide any supply voltage.

1. Unscrew the upper part of the battery capsule (3) (arrow).
2. Insert a button cell of type LR44 into the battery compartment according to the polarity (+/−) indicated in the compartment.
3. Close the battery capsule.

Note: Remove the battery if it is not used for a longer period of time; it may leak into the battery compartment and cause damage.

Never put batteries in the household waste. Always dispose of the batteries in accordance with local regulations.

Operation

1. Place the foam windshield on the microphone (1) as shown in figure 1.
2. Use the clip (2) to attach the microphone to your clothes. The ideal distance from your mouth is about 20 – 25 cm.
3. To attach the battery capsule (3) to your clothes, for example, use the clip on the back.
4. If the microphone input to which the microphone is to be connected provides a supply voltage (e. g. connection of a smartphone), set the switch POWER (4) for the battery supply to the position OFF. If the input does not provide any supply voltage, set the switch to the position ON. In this case, the battery inserted will supply the microphone with power.
5. Connect the plug (5) to a microphone input of a recorder, for example. If necessary, use the adapter (6).
6. To prevent unnecessary discharge of the battery, set the switch to the position OFF after use or when the microphone is not used for a longer period of time.

Frequency response

Polar pattern

Specifications

• Type: ……………….. electret condenser microphone
• Polar pattern: ………………….omnidirectional, ☞ fig. 3
• Frequency range: …………………….65 – 18 000 Hz
• Nominal impedance: ……………………. 1 kΩ
• Sensitivity: …………………………………………………………… 31 mV/ Pa
• Max. SPL: ………………………………………………………………..110 dB
• S/ N ratio: ………………………………………………………………….. ≥ 74 dB
• Power supply: ……………………………………….. 1.5 V (1 × LR44 button cell) or external power supply (e. g. smartphone)
• Ambient temperature: ………0 – 40 °C
• Dimensions
• Microphone: ……………………………. ⌀ 9 mm × 17 mm
• Battery capsule: ………………………………… ⌀ 18 mm × 50 mm
• Weight
• Microphone: ………………………………………….2.5 g
• Battery capsule: …………………………………18 g
• Total weight: ……………………………………………………64.5 g
• Cable length: ………………………………….. 6 m

Subject to technical modification.

Copyright© by MONACOR INTERNATIONAL All rights reserved A-2131.99.01.06.2022 MONACOR INTERNATIONAL GmbH & Co. KG Zum Falsch 36, 28307 Bremen Germany WWW.MONACOR.COM

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>