FourAmZ RX-V100 Robot Vacuum Cleaner User Guide
- June 6, 2024
- FourAmZ
Table of Contents
Preparation before use
Step 1
Remove shield
Be sure to remove the collision protection strip on both sides of the host
crash bar.
Step 2
Install side brushes
Install the edge brush on both sides of the bottom roller of the main machine.
(Refer to the graphic)
Note: Please distinguish the left and right side brushes, and install them correctly.
Step 3
Place charging station and connect the power supply
Place the charging station on the flat ground against the wall, and make sure
the charging station indicator light is on.
Step 4
Start the robot vacuum cleaner
Turn on the switch on the right side of the machine, wait for about 20 seconds
before entering the work. 1.0pen the APP and connect the robot vacuum cleaner
according to the operation step. 2-Run the robot vacuum through the APP/
Built-in Button.
APP Instruction
The app needs to be used in the networked state. Please connect to the home network first and make sure the network is 2.4 GHz Wi-Fi.
-
Download: Scan the QR code and download the “Tuya Smart APP”. For IOS model phones, search for “Tuya Smart” in the APP store to download; For Android model phones, search for Tuya Smart in the app store to download.
http://smart.tuya.com/download -
Sign up: New users enter the registration page by clicking Create New Account. Use an unregistered mobile phone number/email, and set a login password by obtaining a verification code. After registration, you can log in to use.
-
Connect to the APP
• After login. Click Add Device: Click “Small Home Appliances” and then “robot vacuum (Wi-Fi)”;
• Connect 2.4 GHz Wi-Fi and enter the password and click Next;
• At the same time. long-press the “Auto Cleaning” button and the “Spot Cleaning” button to reset the device—WIFI light flashes slowly and you will hear a voice prompt”Network Connection via Hotspot”;
• Click on the upper right corner to switch to “AP Mode”. and click Next;
• Connect the device’s hotspot on the mobile phone WLAN page (The name of the device’s hotspot is “SmartLife-XXXX” or “SL-XXXX”)
• While the device’s hotspot displays ” √ “. go back to the app and continue.
• After a while. the connection will be successful.