Cell2 SL157 Exterior Scene Light User Manual
- June 9, 2024
- Cell2
Table of Contents
Cell2 SL157 Exterior Scene Light
WIRING
INSTALLATION
-
Place the foam pad onto the desired mounting surface and mark the location for the two mounting screws and the wire routing hole location between the two screw holes.
-
Drill two pilot holes for the two 04x16mm (0.15″xO.63″) self tapping Screw and one 014 (0.55″) wire routing hole.
Note : Deburr the wire routing hole thoroughly before feeding the wire. -
Feed the wires through the foam pad and wire routing hole and mount the scene light with the supplied self tapping screws.
-
Mount the snap on bezel onto the scene light.
MOUNTING DIMENSIONS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>