cell2 2209 LED Search Light User Manual
- October 30, 2023
- Cell2
Table of Contents
cell2 2209 LED Search Light
LED Search Light – Wired Specifications
This document provides all the necessary information to properly and safely install the LED search light. Before beginning the installation and operation of your new product, the installation technician and operator must read this manual completely.
- 60W high power output
- 60 degree, 360 degree rotation
- Perfect wire conrolled / remote controller designed, easility adjust speed, rotation
- Beam Pattern: Spot
- Proper installation of this product requires the installer to have a good understanding of automotive electronics, systems and procedures.
- Failure to use specified installation parts or hardware will void the product warranty.
- For this product to operate at optimum efficiency, a good electrical connection to chassis ground must be made.
- It is recommend that these instructions be stored in a safe place and referred to when performing maintenance or reinstallation of this products.
- Do not install and/or operate this safety product unless you have read and understand the safety information contained in this manual.
This document provides all the necessary information to allow your product to be properly and safely installed. Before beginning the installation and operation of your new product, the installation technician and operator must read this manual completely.
Wire Control Instruction Manual
This manual describes how to use the remote search light. In this manual, you will learn about:
- Basic function of the wire control
- Connect the light to wire control
Basic Functions
To wire control the LED search light, it must be connected to the wire control. The basic functions are:
- On: Turn on the light
- Off: Turn off the light
- Up: Head up
- Down: Head down
- Left: Turn left
- Right: Turn right
- Fast rotation: Fast speed rotation
- Slow rotation: Slow speed rotation
Connect the Light to Wire Control
To connect the LED search light to the wire control, follow these steps:
- Locate the wire control and ensure it is turned off.
- Connect the wire control to the LED search light using the provided cable.
- Turn on the wire control and test the basic functions of the LED search light.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>