cell2 MS3 Surface Mount User Manual
- June 9, 2024
- Cell2
Table of Contents
cell2 MS3 Surface Mount
Surface Mount
Connect YELLOW wires of all heads together for synchronization (All heads must be set at the same pattern)
For Simultaneous or Alternating Flash
- Apply +VDC to RED and YELLOW wires simultaneously to enter Grouping mode; lighthead will display short (single or double) flashes:
- Single flash = Group1
- Double flash = Group2
- Remove YELLOW wire from +VDC and momentarily apply to +VDC to change Groups:
- Heads in the same Group flash together.
- Group1 Heads alternate with Group2 Heads
For Flash Patterns:
Momentarily apply +VDC to YELLOW wire:
- once for next pattern
- quickly three times for pattern 0
| FP# | Flash Patterns |
|---|---|
| 0 | Random |
| 1 | Single |
| 2 | Single |
| 3 | Mega |
| 4 | Double |
| 5 | Triple |
NOTE : This unit may not be factory set at FP# 0.
Adhesive Mount
- Select mounting location and clean surface.
- Peel one side of adhesive and apply to lighthead base.
- Peel other side of adhesive and secure lighthead firmly to the mounting surface
NOTE : Optimun adhesive strength is achieved after 24hrs
Screw Mount
- Select a mounting location.
- Mark and drill mounting holes.
- Place the rubber pad to the bottom of the lighted base.
- Secure light head to the mounting surface with supplied screws
Bracket Mount
- Select a mounting location.
- Place the rubber pad to the bottom of the lighted base.
- Place light head to the mounting surface.
- Align top holes of the bracket onto the lighted base alignment points.
- Secure lightheaded with supplied screws from the bottom of the bracket
Unit 4 Premus, Brunel Park, Coldharbour Way Aylesbury, Buckinghamshire HP19
8AP
web: www.cell2.com email :
sales@cell2.com tel : +44(0)2033 285 494
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>