Cell2 R65 Mini Light Head User Manual
- June 9, 2024
- Cell2
Table of Contents
R65 MINI LIGHT HEAD
User Manual
Surface Mount
Connect YELLOW
wires of multiple light heads together for synchronization
(All heads should be set at the same Flash Pattern)
For Simultaneous or Alternating Flash:
-
Apply +VDC to RED and YELLOW wires simultaneously to enter Grouping mode; lightheaded will display short (single or double) blips:
• Single flash = Group1
• Double flash = Group2 -
Remove YELLOW wire from +VDC then momentarily apply +VDC to change Groups:
• Heads of the same Group will flash together.
• Heads of the different Group will flash alternately.
For Flash Patterns:
Momentarily apply +VDC to YELLOW wire:
- once for next pattern
- quick three times for pattern 1
Flash Patterns
1| Single (R65)
2| Double (R65)
3| Triple (R65)
4| Quad (2Hz)
5| Steady
Adhesive Mount
- Select a mounting location and clean the surface.
- Peel one side of the adhesive and apply to the lightheaded base.
- Peel the other side of the adhesive and secure the head firmly to the surface.
NOTE: Optimum adhesive strength is achieved after 24hrs.
Screw Mount
- Select a mounting location for the lightheaded.
- Mark and drill mounting holes.
- Place the rubber pad to the bottom of the base.
- Secure the head to the mounting surface with supplied screws.
Bracket Mount
- Select a mounting location for the lightheaded.
- Place the rubber pad to the bottom of the base.
- Place the head to the mounting surface.
- Align top holes of the bracket onto the lighted base alignment points.
- Secure the head with supplied screws from the bottom of the bracket.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>