Intelligent AQE-ATT-701 Countertop Wash Basin User Manual
- June 9, 2024
- Intelligent
Table of Contents
Intelligent AQE-ATT-701 Countertop Wash Basin
General Installation
- To the installer: Please read and follow this instruction carefully, as the guarantee is only valid if the product is installed as directed.
- The installation of this Basin requires the preferred previous installation of a suitably constructed countertop.
- Please ensure that the countertop is suitable for the weight allowance of the basin and its components.
- Don’t rush, read the instructions first and run through them before you begin. Keep fittings together to avoid loss.
- Do not over-tighten screws or bolts.
- If the unit is covered with polyethylene protective film, do not remove until installation is complete to grant maximum protection.
- However, remove f ilm where any two surfaces will be in permanent contact.
- Verify that all dimensions on the plan are the same as the ones of the product.
- Please leave this installation manual with the end user once the product has been installed.
TOOLS REQUIRED (Not supplied)
Drill, drill bits
-
* Required when securing the wash basin to a wall. Use an appropriate size bit to match the wall fixing chosen (wall screws and fixings may not be supplied).- Mark a line horizontal of 850-900mm, this is a recommended height that the wall mounted basin should be installed at, Using the basin measurements mark line C and line B .
- Using the wash basin fixing kit, gauge the correct diameter and depth for the wall plug and use corresponding drill bit to make the holes in the surface.
- Insert the wall plug, and then screw in the the threaded hanger bolt to the required depth.
- Install the wash basin onto the threaded hangers, a second person will be required to hold the wash basin in position whilst fixing.
- Place the spacer, followed by the washer onto the threaded hangers and then hand tighten with the nut, place a level along the back edge and check before fully fastening
- To finish place a small bead of silicon along the back edge of the wash basin
Product Aftercare
- We recommend cleaning with a soft damp cloth and mild soap solution.
- Do not use cream cleaners or cleaners containing bleach.
- Do not scrub or scour.
- Do not use abrasive cleaning agents.
- Do not use solvent-based cleaners.
IMPORTANT PLEASE READ
- Remove all packaging and check the product for missing parts or damage before starting installation.
- Any alterations made to this product and fittings may infringe water regulations and invalidate the guarantee.
- The Installation must comply with all Local/National Water Supply Authority
- Regulations/Byelaws and Building and Plumbing Regulations.
- We strongly recommend that your product be installed by a reputable qualified trade’s person.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>